Club Cobra - View Profile: racer59

racer59
CC Member

Last Activity: 04-13-2013 10:16 AM

Showing Visitor Messages 1 to 7 of 7

06-28-2013 10:15 AM - permalink
kingsbolt

Hey Racer,

R u a member of the West Coast Cobra Club? Because there is some discussion on the soft top going on now you might have something to add.
- View Conversation
07-09-2010 05:01 PM - permalink
hotwhelrob

Cobra is OK. My running hot problem was 2 part. First the water level was low. I figured out that it takes a lot of water in the tank to be full. The second thing was the gage. It is reading higher temps than actual. I put a screw in gage on the manifold and the temp stays at 185-190. I have not tried to change the sending unit.
Now on to a clutch problem....
- View Conversation
02-07-2010 09:44 PM - permalink
racer59

Good Evening Bob,
I will call Mike re: Uphostery.
Thank you very much.
Regards,
Julio.
01-27-2010 04:40 PM - permalink
scottsdale Bob

Julio Found this in some old papers. They used to make the soft tops for West Coast. Donalds Upholstery (704-392-2931) Mike. Good Luck
- View Conversation
01-24-2010 02:55 AM - permalink
racer59

Thanks Bob in regards to my inquiry re: Soft top.
Julio.
01-22-2010 10:29 AM - permalink
scottsdale Bob

Julio Don"t have a top. Sorry
- View Conversation
01-21-2010 06:17 PM - permalink
racer59

Is there any one out there that owns a West Coast Cobra. Older generation?
Wanted to find out how to install the Soft top on the car.
No mounting holes but there is what appeared to be a hole covered up in my older generation West coast cobra.
Thanks.
Julio