Club Cobra Keith Craft Racing  

Go Back   Club Cobra > Members List
Reload this Page BDR0572's Profile
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts


BDR0572
CC Member

Last Activity: 04-10-2025 06:14 AM

About Me

  • About BDR0572
    Zip Code
    77568
    City
    LaMarque
    State
    TX
    Country
    USA
    Cobra Make, Engine
    BDR, Roush 402R
    Ride
    Roadster RT2
    Engine type and displacement
    VMS Roush 402R
    Major modifications
    Upgraded cam
    Tranny type
    TKO 500 5 Speed
    Horsepower
    442WHP

Statistics

Total Posts
Albums
General Information
  • Last Activity: 04-10-2025 06:14 AM
  • Join Date: 11-15-2014

Likes Given

275 Likes
  1. BDR0572
    BDR0572 liked post by spdbrake On thread : Starter PN
    Is the issue not charging while driving or the battery is low on charge after sitting? If its draining this may help in looking for parasitic drains. How to Find and Stop Car Battery Drains...
    Liked On: 07-07-2016, 07:15 PM
    Posted On: 07-07-2016, 09:07 AM
  2. BDR0572
    BDR0572 liked post by Mark IV On thread : Changing a Clutch on a Backdraft
    Alignment of the pushrod is very important, you want minimum in-out/up-down movement when activated. This is hard to achieve as the clutch arm swings in an arc but it can be held to a minimum with...
    Liked On: 07-05-2016, 06:19 AM
    Posted On: 07-02-2016, 05:14 AM
  3. BDR0572
    BDR0572 liked post by Bernica On thread : Oil Drain Plug(s)??
    Get yourself a slip wrench filter tool. If no room for the handle, get one that accepts a socket extension like this. Then treat yourself to a nice WIX filter when you change.;) Oil Filter...
    Liked On: 07-02-2016, 06:58 PM
    Posted On: 07-02-2016, 06:39 PM
  4. BDR0572
    BDR0572 liked post by Cashburn On thread : Rubber side pipe hangers for a BDR
    I ordered the hangers based on the make/model you used from rockauto and got something completely different. So be careful on who you order from since there are some varieties to the parts sold for...
    Liked On: 06-30-2016, 06:25 PM
    Posted On: 06-07-2007, 06:42 AM
  5. BDR0572
    BDR0572 liked post by spdbrake On thread : BDR - Manual Rack Boots
    I'd contact Backdraft Parts - Home page (http://www.backdraftparts.com) as the manual rack is sold there and Bryan in parts can probably break it down by PN and or source for you. Barring that you...
    Liked On: 06-30-2016, 06:22 PM
    Posted On: 06-30-2016, 03:06 PM
  6. BDR0572
    BDR0572 liked post by spdbrake On thread : Rubber side pipe hangers for a BDR
    I also bought a set for 255-525 hangers but the center web was pretty thin and the rubber pretty soft. Didn't think they'd last very long. Removed my frame mounted hangers and redrilled them to...
    Liked On: 06-28-2016, 08:21 AM
    Posted On: 06-08-2016, 06:28 PM
  7. BDR0572
    BDR0572 liked post by cycleguy55 On thread : Backdraft Oil Filter
    I had a remote filter and took it off as there were too many elbows (flow restriction) and the damn thing leaked too much for my liking. I replaced it with a Ford Racing 90° Oil Filter Adapter (p/n...
    Liked On: 06-23-2016, 08:05 PM
    Posted On: 06-22-2016, 02:34 PM
  8. BDR0572
    BDR0572 liked post by spdbrake On thread : Backdraft Brake Bleeder Screw
    If you have a metric and SAE tap and dies set to measure would be handy as they have thread pitch gauge in them. Or run down to the local ACE Hardware to match up via their hardware bins for Dia and...
    Liked On: 06-23-2016, 07:59 PM
    Posted On: 06-22-2016, 11:11 AM
  9. BDR0572
    BDR0572 liked post by Cashburn On thread : Driveline Lash
    Check all driveshaft bolts and most importantly that main diff bolt is very tight (like 3' breaker bar tight).
    Liked On: 06-07-2016, 04:58 PM
    Posted On: 06-07-2016, 12:20 PM
  10. BDR0572
    BDR0572 liked post by bobcowan On thread : Drive Shaft Alignment
    Maybe it's OK, and maybe it's not. As said above, the drive shaft should not be straight. But, the pinion angles need to be properly aligned in both planes - vertical and horizontal. Do a...
    Liked On: 06-02-2016, 07:28 PM
    Posted On: 06-02-2016, 07:05 AM
  11. BDR0572
    BDR0572 liked post by Mark IV On thread : Broken Diff
    About 2.5 but you want to fill to about 1/4" BELOW the side fill port. TKOs shift better at higher RPMs with a little less fluid. Tremec has even admitted this with a service bulletin. Make up a...
    Liked On: 05-29-2016, 01:46 PM
    Posted On: 05-28-2016, 10:17 AM
  12. BDR0572
    BDR0572 liked post by Kobura On thread : Am I that dumb?
    There is at least one thread on this problem. You can search for it. Basically, the discussion involves the 3/8" vent line. Check for kinks/blockage. Good luck.
    Liked On: 05-28-2016, 08:21 PM
    Posted On: 05-28-2016, 03:24 PM
  13. BDR0572
    BDR0572 liked post by BDR427R On thread : Weird Noise From Side Pipes....Search Performed...Additional Questions
    http://www.clubcobra.com/forums/picture.php?albumid=3535&pictureid=15370&thumb=1 ('http://www.clubcobra.com/forums/picture.php?albumid=3535&pictureid=15370') Looks like sh*t Welds. Where would...
    Liked On: 05-08-2016, 05:00 PM
    Posted On: 05-08-2016, 01:51 AM
  14. BDR0572
    BDR0572 liked post by GBowman On thread : Broken Diff
    I had a similar problem last year but I hard launched with super sticky tires on a not so smooth road (yes stupid). I think I have the front cover that you broke if you are interested. I upgraded to...
    Liked On: 05-03-2016, 03:15 PM
    Posted On: 05-02-2016, 11:12 AM
  15. BDR0572
    BDR0572 liked post by patrickt On thread : Broken Diff
    Even without pictures, the general rule is "If it looks bad, it usually is.":cool:
    Liked On: 05-03-2016, 03:07 PM
    Posted On: 05-01-2016, 03:01 PM
Page 17 of 19 « First 7910111213141516 17 1819

All times are GMT -7. The time now is 02:14 PM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink