Club Cobra Keith Craft Motorsports  

Go Back   Club Cobra > Members List
Reload this Page gjkrv8's Profile
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts


gjkrv8
CC Member

Last Activity: 03-10-2025 11:31 PM

About Me

  • About gjkrv8
    City
    Melbourne
    State
    VIC
    Country
    Australia
    Cobra Make, Engine
    Classic Revival CR 3505, LS1, T56 6 Speed, VE 3.45 LSD Rear, 6 Spot AP Fronts, 4 Spot Wilwood Rears
    Engine type and displacement
    LS1 Gen III 5.7L
    Tranny type
    6 Speed Manual

Visitor Messages

Showing Visitor Messages 1 to 3 of 3
  1. velj
    01-15-2013 06:39 AM - permalink
    velj
    hi greg, love the colour, i recently just painted out cobra voodoo blue, but having trouble with the stripe colour, what did you do yours? i like the look of it, also what area are you in? im from northen suburbs of melbourne (macleod)
    once my post gets approved you can see some photos of it
    cheers
  2. gjkrv8
    08-28-2011 11:06 PM - permalink
    gjkrv8
    Hi Dave, Mine is tucked in at the back between the diff and the fuel tank. There is a hose that goes to the engine. There is a little solenoid on the engine that is switched on and off by the ECU. Its location was on the front passenger side of my engine. Not sure about the LS7 though. I am just running a single fuel line up to the engine. They seem to do this in all prod cars and dont have any heat/evap related issues. Also, I'd recommend using a brake padal light switch rather than the pressure switch Ian uses in the rear line. When I have my bias set to favour the front, the brake light takes a bit more pedal pressure to come on which is a little unnerving in traffic when you use a light foot to brake. Hope your build is going well. I think we'll have to organise a shed run when thet weather fines up. Rgds Gregg
  3. DaveW
    08-28-2011 10:58 PM - permalink
    DaveW
    Gregg,
    How are you, if you can remember, how does the carbon canister hookup, did you mount down the back (as per Manual), up the front, do i need to run a vacuum line down to the front, i'm putting in the brake and fuel lines and the manual doesn't give any clear indication about any other lines.
    Cheers, hope your well

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 03-10-2025 11:31 PM
  • Join Date: 04-11-2008

Likes Received

312 Likes
  1. Tenrocca
    Tenrocca liked post by gjkrv8 On thread : 21st Cobra Nationals
    Close - found out my Accel pedal was hitting the side louvre protrusion into the footwell. Was only ever at 80%, feels a lot better now I have WOT :-) (Had to put in a led shift thingy as it was...
    Liked On: 09-08-2014, 09:47 PM
    Posted On: 09-08-2014, 09:00 PM
  2. Gav
    Gav liked post by gjkrv8 On thread : 21st Cobra Nationals
    Close - found out my Accel pedal was hitting the side louvre protrusion into the footwell. Was only ever at 80%, feels a lot better now I have WOT :-) (Had to put in a led shift thingy as it was...
    Liked On: 09-08-2014, 09:29 PM
    Posted On: 09-08-2014, 09:00 PM
  3. Gav
    Gav liked post by gjkrv8 On thread : Aussie car buyers may soon be able to import direct
    I think there's a better chance of my hair growing back than this happening :-) . Too many vested interests. Cheers Gregg
    Liked On: 09-04-2014, 03:27 AM
    Posted On: 09-04-2014, 01:25 AM
  4. Tenrocca
    Tenrocca liked post by gjkrv8 On thread : Wheel Alignment Jig
    Ooooo I like that QuickTrick tool - you know I googled my little heart out for something around that price and came up zero. Looks pretty neat. Regarding Squaring up - essentially you make sure...
    Liked On: 07-21-2014, 12:06 AM
    Posted On: 07-20-2014, 09:08 PM
  5. Gav
    Gav liked post by gjkrv8 On thread : Wheel Alignment Jig
    Ooooo I like that QuickTrick tool - you know I googled my little heart out for something around that price and came up zero. Looks pretty neat. Regarding Squaring up - essentially you make sure...
    Liked On: 07-20-2014, 11:32 PM
    Posted On: 07-20-2014, 09:08 PM
  6. LoBelly
    LoBelly liked post by gjkrv8 On thread : Wheel Alignment Jig
    Its been a slow few days on the forum so I thought I'd put up something I did recently. Also Melb weather hasn't been conducive to Cobra driving too :-( My Wheel alignment/camber had been...
    Liked On: 07-20-2014, 04:24 PM
    Posted On: 07-18-2014, 06:43 PM
  7. itempany
    itempany liked post by gjkrv8 On thread : Any one had Bad fuel
    I reckon I got some (bad fuel) the other day in my daily driver which is a 3.0L Subaru Liberty that has to have premium unleaded :-( . The thing would ping and carry on about 2000-2500RPM. Once I...
    Liked On: 07-14-2014, 12:34 AM
    Posted On: 07-13-2014, 04:17 PM
  8. renovationinnov
    renovationinnov liked post by gjkrv8 On thread : A miracle....Slowy's cobra update
    Slowy, Regarding your Oil Pressure sender - as it is a single wire sender your sender needs to have a good earth - I notice you have a lots of thread tape - just check you have zero ohms...
    Liked On: 06-05-2014, 02:53 AM
    Posted On: 06-05-2014, 02:28 AM
  9. Modena
    Modena liked post by gjkrv8 On thread : A miracle....Slowy's cobra update
    Slowy, Regarding your Oil Pressure sender - as it is a single wire sender your sender needs to have a good earth - I notice you have a lots of thread tape - just check you have zero ohms...
    Liked On: 06-05-2014, 02:41 AM
    Posted On: 06-05-2014, 02:28 AM
  10. Rog246
    Rog246 liked post by gjkrv8 On thread : Stiffy's Shed Update
    I am soooooooooooooooo jealous. I am going to have a garage like yours in my next life :-) cheers Gregg
    Liked On: 05-27-2014, 05:18 AM
    Posted On: 05-27-2014, 04:57 AM
  11. Towmaster
    Towmaster liked post by gjkrv8 On thread : Enjoy your time here
    I reckon there should be a "whinge" or "Complaints" thread. If you want to whinge or complain put it there an don't bugger up other peoples threads. If someone else then wants to see who's...
    Liked On: 05-13-2014, 11:04 PM
    Posted On: 05-13-2014, 02:45 AM
  12. Gav
    Gav liked post by gjkrv8 On thread : Enjoy your time here
    I'm just glad he didn't include Bald blokes :-)
    Liked On: 05-13-2014, 06:43 PM
    Posted On: 05-13-2014, 03:52 PM
  13. Tonus72
    Tonus72 liked post by gjkrv8 On thread : Enjoy your time here
    I reckon there should be a "whinge" or "Complaints" thread. If you want to whinge or complain put it there an don't bugger up other peoples threads. If someone else then wants to see who's...
    Liked On: 05-13-2014, 04:57 AM
    Posted On: 05-13-2014, 02:45 AM
  14. deano59
    deano59 liked post by gjkrv8 On thread : ebay cobra
    whoops sorry - I should have known I got it wrong as I also bought stuff from Snakebite on the past. Yes typo - meant Snakepit. cheers Gregg
    Liked On: 05-13-2014, 04:39 AM
    Posted On: 05-13-2014, 04:38 AM
  15. Rog246
    Rog246 liked post by gjkrv8 On thread : Enjoy your time here
    I reckon there should be a "whinge" or "Complaints" thread. If you want to whinge or complain put it there an don't bugger up other peoples threads. If someone else then wants to see who's...
    Liked On: 05-13-2014, 04:15 AM
    Posted On: 05-13-2014, 02:45 AM
Page 18 of 21 « First 81011121314151617 18 192021

All times are GMT -7. The time now is 11:14 AM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink