Club Cobra - View Profile: Apex

Apex_speed
CC Member

Last Activity: 05-13-2022 09:01 AM

About Me

About Apex_speed

City

Denver

State

CO

Country

USA

Cobra Make, Engine

Superformance Mk3 with Roush 427R

Engine type and displacement

427

Statistics

Total Posts

General Information

Last Activity: 05-13-2022 09:01 AM
Join Date: 05-07-2018

Likes Given

23 Likes

Apex_speed liked post by Andheeezonit On thread : Adding a driver's shoulder harness bar?

I agree with 1795. I installed RJS V belts on 3153 through the bulkhead and it’s a very clean install with no worry of damaging the paint.
Liked On: 06-14-2018, 09:05 AM
Posted On: 06-14-2018, 05:07 AM
Apex_speed liked post by Three Peaks On thread : Starter Recommendations?

I installed a mini starter on my 393 with 10.5 compression and haven't had any problems with it. Bob
Liked On: 06-11-2018, 10:29 AM
Posted On: 06-10-2018, 10:02 PM
Apex_speed liked post by Dwight On thread : Starter Recommendations?

Summit sells one. What size is your cable from the battery to the starter? I recommend #2 awg welding lead (fine strand wire) that will carry a lot of amps.
Liked On: 06-10-2018, 09:34 PM
Posted On: 06-10-2018, 08:51 PM
Apex_speed liked post by Dwight On thread : Starter Recommendations?

check these out ...
Liked On: 06-10-2018, 09:34 PM
Posted On: 06-10-2018, 08:55 PM
Apex_speed liked post by Dwight On thread : Starter Recommendations?

here is another source I have bought several and they are good starters. Don't let the price scare you. https://www.dbelectrical.com/starters/automotive/ford/mini-hi-torque/
Liked On: 06-10-2018, 09:34 PM
Posted On: 06-10-2018, 08:59 PM
Apex_speed liked post by Three Peaks On thread : Starter Recommendations?

First things first. Make sure all your connections are extremely clean and no corrosion, then retighten very well. Also, make sure you have a good ground to the engine and the starter. If you can,...
Liked On: 06-10-2018, 09:34 PM
Posted On: 06-10-2018, 09:01 PM
Apex_speed liked post by Gaz64 On thread : Fuel Return Line Ideas?

Sounds like you getting somewhere now. Gary
Liked On: 05-18-2018, 05:04 PM
Posted On: 05-18-2018, 05:04 PM
Apex_speed liked post by cycleguy55 On thread : OK to put temp senor in waterpump bypass line?

BTW, the fitting on the intake manifold is the hot coolant to the heater, and the heater return goes to the water pump.
Liked On: 05-17-2018, 08:04 AM
Posted On: 05-16-2018, 07:39 PM

Page 2 of 2

About Me

Statistics

Likes Given

Mini Statistics

Recent Visitors