About Me
- About Ozzie Goat
- Zip Code
- 60448
- Biography
- living the dream
- City
- Mokena
- State
- IL
- Country
- United States
- Cobra Make, Engine
- Backdraft SBF-302
- Engine type and displacement
- 302
-
Signature
- Roy
Likes Given
173 Likes
-
Ozzie Goat liked post by patrickt On thread : Battery volts dropThat's all there is a to a charging circuit in these cars. Just the alternator, the voltage regulator, and the wires and connections in between. The problem is always in one of those three...Liked On: 08-05-2022, 06:39 PM
Posted On: 03-25-2016, 09:12 AMOzzie Goat liked post by allcarfan On thread : Battery volts dropCruise at 2400rpms.....flick on heater..... appears to be 1.5v loss. Continued driving for 10 min...no change. Flick off heater....immediate 14.7vLiked On: 08-05-2022, 06:34 PM
Posted On: 03-22-2016, 10:03 AMOzzie Goat liked post by Cashburn On thread : Burping Cooling SystemPark it on incline, nose up and let it run with cap off. We use a pressure bleed system now but that method worked for our first 6 years.Liked On: 07-13-2022, 09:19 AM
Posted On: 09-08-2013, 02:25 PMOzzie Goat liked post by FlyingGumby On thread : Backdraft - broken bolt on rear trailing arm bracketEverything has been back together and aligned for a couple weeks. Noticeable improvement. Tracks straight on hard acceleration, and at low, med and high speeds. Steering is sharp, light and tight. ...Liked On: 07-12-2022, 07:32 AM
Posted On: 07-11-2022, 08:30 PMOzzie Goat liked post by eschaider On thread : Coyote OwnersThe dipstick does not indicate oil volume in the oil pan. It only indicates the oil level the engine manufacturer does not want you to exceed for windage purposes. When you exceed the normal fill...Liked On: 07-11-2022, 07:23 AM
Posted On: 07-11-2022, 01:02 AMLinks monetized by VigLinkOzzie Goat liked post by spdbrake On thread : BDR OEM radiator/cap/pressureThe higher #s caps allow the temps to run higher without turning to steam (think of a pressure cooker) The cap seal is two stage. lower seal at spring is the 16 or 18 psi setting and will unseat...Liked On: 06-23-2022, 06:44 AM
Posted On: 10-04-2016, 10:57 AMOzzie Goat liked post by spdbrake On thread : Derp of the weekI thought it was another C&C event at first... https://www.roadandtrack.com/news/a39878521/florida-ford-gt-owner-crashes-because-hes-unfamiliar-with-manual-transmission/Liked On: 05-03-2022, 01:42 PM
Posted On: 05-03-2022, 01:32 PMOzzie Goat liked post by 6TNCRZY On thread : Won't start -Need helpMake sure you have a ground cable chassis to engine.Liked On: 04-23-2022, 04:13 PM
Posted On: 04-23-2022, 10:47 AMOzzie Goat liked post by eschaider On thread : Bolt Pitch169mph, look at where you original fastener broke. It broke at the root of a thread. Thread roots are high stress locations on fasteners. Threads are not meant to be placed in shear (side) load,...Liked On: 03-29-2022, 05:55 PM
Posted On: 03-29-2022, 12:03 PMOzzie Goat liked post by john chesnut On thread : Real Men Drive ToplessI love driving topless! :). The day after building this car I left my home in NH and drove it to CA. It was April, 34 degrees and spitting snow. No top. No heater. I took it to a kit car show...Liked On: 03-22-2022, 05:49 PM
Posted On: 03-22-2022, 04:52 PMOzzie Goat liked post by LittlePig On thread : Seat CushionsOzzie, did they bolt straight to the floor, and are you sitting at the same height?Liked On: 03-14-2022, 11:00 AM
Posted On: 03-13-2022, 05:55 PMOzzie Goat liked post by Mark IV On thread : knockoff spinner toolAny tool that does not have a "shock" will not properly tighten a knock-off. A wrench will not do that.Liked On: 03-11-2022, 10:42 AM
Posted On: 03-05-2022, 02:52 PMOzzie Goat liked post by spdbrake On thread : E36 output spacersUnfortunately no. The spacers are not BMW E36. Sometime in the last decade BDR switched to different shorter axles and integral splined rear hubs along with ventilated rear rotors and ditched the...Liked On: 03-03-2022, 06:00 PM
Posted On: 03-03-2022, 02:45 PMOzzie Goat liked post by RUFdriver On thread : Finally got my Cobra!Finally took delivery of my Cobra from UCC on Saturday, the car turned out great. Albeit the 10 day build took nearly 2 years LOL, it’s all good standard procedure on these builds. Now to register it...Liked On: 02-08-2022, 08:36 AM
Posted On: 02-08-2022, 08:15 AM
All times are GMT -7. The time now is 02:09 PM.






Likes Received