Club Cobra Keith Craft Racing  

Go Back   Club Cobra > Members List
Reload this Page patrickt's Profile
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts


patrickt
Half-Ass Member

Last Activity: Today 04:14 PM

About Me

Statistics

Total Posts
General Information
  • Last Activity: Today 04:14 PM
  • Join Date: 06-25-2005

Friends

Showing Friends 1 to 6 of 6

Likes Received

1894 Likes
  1. kmn5
    kmn5 liked post by patrickt On thread : Floor mounted pedals
    And you can tweak them a bit if you have fat feet. http://www.clubcobra.com/photopost/data/500/medium/121_2116.JPG
    Liked On: 06-13-2024, 05:35 AM
    Posted On: 06-05-2024, 06:55 PM
  2. 1795
    1795 liked post by patrickt On thread : 427 Heads
    Any stroked and bored FE will put down 500 horsepower on the dyno -- that's a piece of cake for any decent engine builder. And you can't use it on the street. Every time you punch the throttle your...
    Liked On: 06-11-2024, 01:33 PM
    Posted On: 06-07-2024, 05:00 PM
  3. Daytona Dek
    Daytona Dek liked post by patrickt On thread : Hot starting problem.
    Or... we could write down every possible repair we can think of on pieces of paper and then put them all in a hat. Every couple of days the OP pulls a piece of paper out of the hat and performs that...
    Liked On: 06-10-2024, 12:32 PM
    Posted On: 06-09-2024, 10:23 AM
  4. eschaider
    eschaider liked post by patrickt On thread : 427 Heads
    Any stroked and bored FE will put down 500 horsepower on the dyno -- that's a piece of cake for any decent engine builder. And you can't use it on the street. Every time you punch the throttle your...
    Liked On: 06-07-2024, 08:58 PM
    Posted On: 06-07-2024, 05:00 PM
  5. twobjshelbys
    twobjshelbys liked post by patrickt On thread : 427 Heads
    Any stroked and bored FE will put down 500 horsepower on the dyno -- that's a piece of cake for any decent engine builder. And you can't use it on the street. Every time you punch the throttle your...
    Liked On: 06-07-2024, 05:56 PM
    Posted On: 06-07-2024, 05:00 PM
  6. CompFi
    CompFi liked post by patrickt On thread : Troubleshooting my FE
    You can go only go so far bench-setting a carb for a performance engine that has an intake manifold that doesn't even sit level. Your floats are never going to be right until you set them when...
    Liked On: 06-06-2024, 09:04 PM
    Posted On: 06-06-2024, 04:58 AM
  7. CompFi
    CompFi liked post by patrickt On thread : Troubleshooting my FE
    That is true... but it's doubtful it would cause the engine to begin overheating. But we can put it on the check list.:cool:
    Liked On: 06-05-2024, 05:30 PM
    Posted On: 06-05-2024, 03:58 PM
  8. CompFi
    CompFi liked post by patrickt On thread : Troubleshooting my FE
    What's the exact model number for your carb?
    Liked On: 06-04-2024, 03:13 PM
    Posted On: 06-04-2024, 02:54 PM
  9. CompFi
    CompFi liked post by patrickt On thread : Troubleshooting my FE
    That looks new, and fine. Proceed to looking with a mirror to see if you lost a vacuum tube cap.
    Liked On: 06-04-2024, 12:20 PM
    Posted On: 06-04-2024, 12:10 PM
  10. CompFi
    CompFi liked post by patrickt On thread : Troubleshooting my FE
    OK, for now just take the distributor cap off, it lifts right off after you turn the two lock down a half turn each, and look to see if the springs are broken.
    Liked On: 06-04-2024, 10:45 AM
    Posted On: 06-04-2024, 10:32 AM
  11. eschaider
    eschaider liked post by patrickt On thread : Looking for a Used ERA S/C Cobra
    I will tell you it's a wonderful experience to have ERA build you a custom car that is exactly what you spec out down to the last bolt. But, unfortunately, and through no fault of ERA, doing that is...
    Liked On: 06-02-2024, 01:17 PM
    Posted On: 06-01-2024, 05:47 PM
  12. CompFi
    CompFi liked post by patrickt On thread : Looking for a Used ERA S/C Cobra
    I will tell you it's a wonderful experience to have ERA build you a custom car that is exactly what you spec out down to the last bolt. But, unfortunately, and through no fault of ERA, doing that is...
    Liked On: 06-01-2024, 08:49 PM
    Posted On: 06-01-2024, 05:47 PM
  13. Tommy
    Tommy liked post by patrickt On thread : Newbie to the group
    For the first few months drive it like a little ol' lady unless you're in a huge parking lot where there are no light poles, cement curbs, or anything else to damage your car. That's the perfect...
    Liked On: 05-31-2024, 04:28 AM
    Posted On: 05-21-2024, 06:07 PM
  14. Ron61
    Ron61 liked post by patrickt On thread : Reviving Dead Cobra
    Tom brings up a good point. But, with 93 octane E85, an aluminum turkey pan and keeping the levels in the bowls just a bit lower than the 60 year old "to the sight hole" rule, my Holley 3310 can...
    Liked On: 05-29-2024, 07:03 AM
    Posted On: 05-28-2024, 07:02 PM
  15. CompFi
    CompFi liked post by patrickt On thread : Reviving Dead Cobra
    Tom brings up a good point. But, with 93 octane E85, an aluminum turkey pan and keeping the levels in the bowls just a bit lower than the 60 year old "to the sight hole" rule, my Holley 3310 can...
    Liked On: 05-28-2024, 09:01 PM
    Posted On: 05-28-2024, 07:02 PM
Page 5 of 127 1234 5 6789101112131555105 Last »

All times are GMT -7. The time now is 07:59 PM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink