Club Cobra Keith Craft Motorsports  

Go Back   Club Cobra > Members List
Reload this Page gjkrv8's Profile
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts


gjkrv8
CC Member

Last Activity: 03-10-2025 11:31 PM

About Me

  • About gjkrv8
    City
    Melbourne
    State
    VIC
    Country
    Australia
    Cobra Make, Engine
    Classic Revival CR 3505, LS1, T56 6 Speed, VE 3.45 LSD Rear, 6 Spot AP Fronts, 4 Spot Wilwood Rears
    Engine type and displacement
    LS1 Gen III 5.7L
    Tranny type
    6 Speed Manual

Visitor Messages

Showing Visitor Messages 1 to 3 of 3
  1. velj
    01-15-2013 06:39 AM - permalink
    velj
    hi greg, love the colour, i recently just painted out cobra voodoo blue, but having trouble with the stripe colour, what did you do yours? i like the look of it, also what area are you in? im from northen suburbs of melbourne (macleod)
    once my post gets approved you can see some photos of it
    cheers
  2. gjkrv8
    08-28-2011 11:06 PM - permalink
    gjkrv8
    Hi Dave, Mine is tucked in at the back between the diff and the fuel tank. There is a hose that goes to the engine. There is a little solenoid on the engine that is switched on and off by the ECU. Its location was on the front passenger side of my engine. Not sure about the LS7 though. I am just running a single fuel line up to the engine. They seem to do this in all prod cars and dont have any heat/evap related issues. Also, I'd recommend using a brake padal light switch rather than the pressure switch Ian uses in the rear line. When I have my bias set to favour the front, the brake light takes a bit more pedal pressure to come on which is a little unnerving in traffic when you use a light foot to brake. Hope your build is going well. I think we'll have to organise a shed run when thet weather fines up. Rgds Gregg
  3. DaveW
    08-28-2011 10:58 PM - permalink
    DaveW
    Gregg,
    How are you, if you can remember, how does the carbon canister hookup, did you mount down the back (as per Manual), up the front, do i need to run a vacuum line down to the front, i'm putting in the brake and fuel lines and the manual doesn't give any clear indication about any other lines.
    Cheers, hope your well

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 03-10-2025 11:31 PM
  • Join Date: 04-11-2008

Likes Given

478 Likes
  1. gjkrv8
    gjkrv8 liked post by Gav On thread : 2017 Bathurst 12Hr
    Don't feel left out Greggy, I'll be thinking of you while downing beer in our corporate box.
    Liked On: 01-26-2017, 05:43 AM
    Posted On: 01-25-2017, 09:10 PM
  2. gjkrv8
    gjkrv8 liked post by Gav On thread : Help on Logistics of importing a FFR mk 4 roadster
    Well that's how it's done. Job's sorted. Stiff, Ken may be a new member!
    Liked On: 01-24-2017, 12:14 AM
    Posted On: 01-23-2017, 10:16 PM
  3. gjkrv8
    gjkrv8 liked post by DaveW On thread : Best Cobra Kit Car to Purchase
    CR Chassis...yeah... I might never finish mine i spend so long staring at it. http://i1060.photobucket.com/albums/t448/CR3514/DSC03773%20Large_zpslubbthqy.jpg ...
    Liked On: 01-21-2017, 04:56 AM
    Posted On: 01-20-2017, 10:04 PM
  4. gjkrv8
    gjkrv8 liked post by Aussie Mike On thread : Best Cobra Kit Car to Purchase
    I see the round tube chassis as a positive for the CR. Yes the Pace is an engineering marvel and looks very easy to build but I think there is still a demand for a car that has a traditional looking...
    Liked On: 01-20-2017, 05:39 AM
    Posted On: 01-19-2017, 09:19 PM
  5. gjkrv8
    gjkrv8 liked post by Aussie Mike On thread : Best Cobra Kit Car to Purchase
    Classic Revival are still in business. Making a nice round tube style chassis that many on here have built.
    Liked On: 01-20-2017, 05:39 AM
    Posted On: 01-19-2017, 06:17 PM
  6. gjkrv8
    gjkrv8 liked post by Gav On thread : 2017 Bathurst 12Hr
    I'll be there! Have got some corporate passes for the weekend this year ��
    Liked On: 01-13-2017, 03:52 PM
    Posted On: 01-12-2017, 09:44 PM
  7. gjkrv8
    gjkrv8 liked post by guye On thread : Off Subject Yank planning a trip
    "Shag"? Perhaps you are referring to a swag BJ? A shag is what you might do in a swag. :)
    Liked On: 01-08-2017, 03:35 PM
    Posted On: 01-08-2017, 12:36 AM
  8. gjkrv8
    gjkrv8 liked post by letsboogie351 On thread : Out with the old and in with the new
    It has been a while but I now have my new seats. With these I now sit a little lower and further back. Most noticeable with the extra room around the knee area. ...
    Liked On: 01-07-2017, 03:40 PM
    Posted On: 01-07-2017, 03:35 PM
  9. gjkrv8
    gjkrv8 liked post by Tenrocca On thread : Lemans Hardtop Install
    Not really about the top, but finally boxed in the pocket in the roof so I can raise the hoist "most" of the way up. Bloody door opener is in the way so I cant quite get the full height with the roof...
    Liked On: 01-06-2017, 03:56 PM
    Posted On: 01-06-2017, 03:00 PM
  10. gjkrv8
    gjkrv8 liked post by Cobrakiller On thread : Brake failure light, self test ADR 31/
    Thanks for the reply's, I found that the ignition switch has a earth contact between the on and start position for the test function circuit.I am using a HZ Holden switch.
    Liked On: 12-31-2016, 07:46 PM
    Posted On: 12-31-2016, 03:14 AM
  11. gjkrv8
    gjkrv8 liked post by kyleb On thread : slowing down power steering
    The other option is to throw the old power steering pump in the trash and get a power steering pump (power-pack) from a 2000ish model MR2 spyder. Mount it anywhere you want and hook it up to the...
    Liked On: 12-27-2016, 08:05 PM
    Posted On: 12-27-2016, 03:53 PM
  12. gjkrv8
    gjkrv8 liked post by boxhead On thread : Cobra Websites, FB, Chatrooms
    Or create the account and post in the pinned thread at top of page, surely your mate knows 10 jokes. 1 joke at a time will get him through. In regards to seeing many PACE builds, it is just...
    Liked On: 12-27-2016, 07:58 PM
    Posted On: 12-27-2016, 05:03 PM
  13. gjkrv8
    gjkrv8 liked post by ICCARS On thread : Big thanks to ICCARS
    No worries Dave, my pleasure. Did you get the link for the rear spoiler also, I think that style of spoiler looks great and wouldn't have it off my GT40 now it's on there..
    Liked On: 12-19-2016, 02:43 PM
    Posted On: 12-19-2016, 05:21 AM
  14. gjkrv8
    gjkrv8 liked post by MikeFromPerth On thread : MikeFromPerth's Pace 427 Build Thread
    stripes guy slaving away: http://i32.photobucket.com/albums/d36/mikesmikes1/Mobile%20Uploads/20161213_091429_zpspqjjfyz6.jpg...
    Liked On: 12-14-2016, 02:17 PM
    Posted On: 12-14-2016, 07:51 AM
  15. gjkrv8
    gjkrv8 liked post by Towmaster On thread : New car trailer
    Bit more progress, nearly have the main area all painted now. Should have it all done by the weekend.
    Liked On: 12-02-2016, 02:27 PM
    Posted On: 12-02-2016, 06:34 AM
Page 8 of 32 1234567 8 91011121314151618 Last »

All times are GMT -7. The time now is 02:18 PM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink