Likes Received
118 Likes
-
ACHiPo liked post by tortuga On thread : SPF adjustable passenger seat rails (fore and aft)Bought from finish line ($39), about an hour and a half along with a trip to the hardware store for some hex RHMS (8mm x about 3/4") to bolt up into the seat. Steps: undo 4 13 mm bolts from under...Liked On: 11-05-2017, 09:32 AM
Posted On: 11-05-2017, 07:36 AMPhx Mike liked post by tortuga On thread : Holley 4150 bowl studs?I was thinking as much as bowls come on and off, and judging by all the thread repair kits available, why not fabricate some 10-24 studs for the bowls? It would also make threading on gaskets,...Liked On: 09-12-2017, 06:16 PM
Posted On: 09-12-2017, 05:33 PMKevinW liked post by tortuga On thread : Show your engine bayHere is the other sideLiked On: 07-21-2017, 01:46 PM
Posted On: 07-18-2017, 07:52 PMLinks monetized by VigLinkeunosracr liked post by tortuga On thread : Hurst Short ShifterEbay: Chrome 3 8 Shift Knob Ball for Hurst Other 3 8 Shifters | eBay...Liked On: 11-20-2015, 12:50 PM
Posted On: 11-20-2015, 09:04 AMeunosracr liked post by tortuga On thread : Hurst Short Shifterremove 4 screws on the boot ring, slip boot off old shifter, remove two 1/2" bolts from the shifter, swap shifters reverse the order...Time including cleaning, getting out and putting away two tools.Liked On: 11-18-2015, 05:28 AM
Posted On: 11-17-2015, 09:22 PMLMH liked post by tortuga On thread : Newest ProblemSorry All, I wish to issue a public apology for my attitude last week...I was had a VERY Crummy week and sort of let it spill over here. I will in the future monitor my threads when i post one to...Liked On: 11-02-2015, 07:32 PM
Posted On: 11-02-2015, 12:09 PMcdnus liked post by tortuga On thread : Newest ProblemAnd the bearing/hub would survive? In my mind's eye i think it would be shot...Liked On: 11-02-2015, 04:24 PM
Posted On: 10-26-2015, 04:00 PMRockBit liked post by tortuga On thread : LED Gauge Lights and Smiths Oil mech Oil # GaugeI was fighting with what i thought was low oil pressure when i came across a post in an MG forum where a guy had the same issue: Turned out the longer LED T10 bulbs interfere with the bourdon tube!...Liked On: 09-30-2015, 05:12 AM
Posted On: 09-29-2015, 04:15 PMMongoose930 liked post by tortuga On thread : LED Gauge Lights and Smiths Oil mech Oil # GaugeI was fighting with what i thought was low oil pressure when i came across a post in an MG forum where a guy had the same issue: Turned out the longer LED T10 bulbs interfere with the bourdon tube!...Liked On: 09-29-2015, 06:41 PM
Posted On: 09-29-2015, 04:15 PMDanMartin liked post by tortuga On thread : Cobra Valley Ball JointsDid them today, 1630-2015 tires to tires...Glad i bought that big a$$ breaker bar, those things were really in there. Pretty straightforward but labor intensive and GREASY. Pre-reallignment...Liked On: 09-18-2015, 11:21 PM
Posted On: 09-18-2015, 08:48 PMACademic liked post by tortuga On thread : Intake manifold off again...CrapTook a bit of advice from all, the rear leak seems gone; used four 5/8-18 SS all-thread studs chased with a die, chased all head threads, cleaned everything as if the pope were visiting, test fitted,...Liked On: 07-08-2015, 07:04 PM
Posted On: 07-08-2015, 05:06 PMMorris liked post by tortuga On thread : Sorry New Owner, lots of Posts: Broken Radiator drain boltI was sort of thinking the same thing, i would rather not give them the whole car for obvious reasons... What is involved in removing the rad? It is really tucked in there from what i can see,...Liked On: 07-07-2015, 05:27 AM
Posted On: 07-06-2015, 08:09 AMJBCOBRA liked post by tortuga On thread : Steam out the stbd exhaust...The really neat thing that i found is that the head gaskets have little tabs that mesh in with the intake manifold gaskets holding them in place! This is the kind of thing that won the war... Also...Liked On: 07-01-2015, 05:56 AM
Posted On: 06-30-2015, 01:30 PM
All times are GMT -7. The time now is 07:51 AM.






Likes Received