About Me
- About FuzzyDiceRide
- City
- Sulphur Springs
- State
- Tx
- Country
- USA
- Cobra Make, Engine
- Hurricane Motorsports #1121 427W
- Tranny type
- TKO 600
Likes Given
51 Likes
-
FuzzyDiceRide liked post by eschaider On thread : Weird engine troubleA mechanical "ticking, tapping sound" where there was none previously does not have an electrical origin; it has a mechanical origin. You can check all the various it isn't that bad sorts of...Liked On: 10-25-2024, 04:44 PM
Posted On: 06-10-2024, 09:13 AMFuzzyDiceRide liked post by Tom Wells On thread : A tribute to Hal CoppleTommy, Here's Hal Copple's piece. I think it was written prior to 2006:Liked On: 02-08-2023, 03:55 PM
Posted On: 02-02-2023, 05:10 PMFuzzyDiceRide liked post by bobcowan On thread : What would it take to put wider tires on a Cobra?You'd be surprised at how little difference a slightly wider tire makes. And you can get too wide and loose performance. Too wide of a tire spreads out the weight across more square mm's. ...Liked On: 11-21-2021, 03:28 AM
Posted On: 11-16-2021, 09:08 PMFuzzyDiceRide liked post by 1985 CCX On thread : problem with steering wheel shakeIf your shocks have dampening you may be set too low. My AC did this as it was on the softest setting causing bounce. Once I dialed it up, handles like a dream.Liked On: 06-21-2021, 11:25 AM
Posted On: 06-21-2021, 10:16 AMFuzzyDiceRide liked post by twobjshelbys On thread : Slave cylinder install HELPThe problem has been solved. Get the Mike Forte kit.Liked On: 10-31-2020, 02:45 PM
Posted On: 09-26-2020, 06:41 PMLinks monetized by VigLinkFuzzyDiceRide liked post by mrmustang On thread : Certain brand pros and consWell said Fred. Bill S.Liked On: 10-31-2020, 02:00 PM
Posted On: 10-18-2020, 07:54 AMFuzzyDiceRide liked post by John248 On thread : Finally did itWell it took two years, but I finally pulled the trigger and ordered a Shell Valley Cobra. Talked with Dana and the build started October 31st. As of two weeks ago the car was done, but finding a...Liked On: 06-10-2020, 03:09 PM
Posted On: 01-02-2020, 08:05 PMFuzzyDiceRide liked post by tomshep On thread : harbor freight jackstands recallSomething my dad taught me years ago is always put the wheel removed under the vehicle as a back-up to the jackstand unless it would be completely in the way for the work needed. You need to put it...Liked On: 06-05-2020, 07:32 PM
Posted On: 05-20-2020, 10:04 PMFuzzyDiceRide liked post by hauss On thread : Who still drives their cobra in the summer heatJust drive the dam thing, stop complaining! You are in a cobra! The sickest most badass car ever made! You are already cool. Hope this helps cool you off.Liked On: 06-05-2020, 07:29 PM
Posted On: 05-27-2020, 09:24 AMFuzzyDiceRide liked post by Texasdoc On thread : Tragic AccidentNO! This will cause off-throttle oversteer and throw you the other way. Let the gas out 50% immediately, then decrease throttle gradually (over a second or two) until back under control. Then you...Liked On: 06-08-2019, 03:09 PM
Posted On: 03-27-2019, 02:28 PMFuzzyDiceRide liked post by Ron Roberts On thread : Firefly exhaust bewareTo: All Yes I know about the Andrew Young post and thanks to all who sent/called over the weekend to inform me of his notes of his actions. First, I would like to apologize for taking up...Liked On: 12-14-2017, 02:47 AM
Posted On: 04-20-2015, 08:25 AMFuzzyDiceRide liked post by jolsen42 On thread : 302 with dual quad edelbrock airgap intakeI have to agree with Larry. I ran an original Cobra dual quad with Edelbrock carbs, I also ran two 6.5 inch air cleaners with two inch filters. It looked quite authenic. John O ...Liked On: 09-15-2016, 06:41 PM
Posted On: 05-17-2016, 03:23 PMFuzzyDiceRide liked post by LMH On thread : 302 with dual quad edelbrock airgap intakeIf it's like the original 8V setup, the Stelling and Hellings air filters had a flat base and were a little under 2" high. The carb centers are 6.5", so it limits what air cleaners you can use. The...Liked On: 09-15-2016, 06:40 PM
Posted On: 05-16-2016, 12:13 PMFuzzyDiceRide liked post by elmariachi On thread : Referred to Hurricane by a friendNo, it was called Component Craft and started by Jerry Connelly in Dallas. The molds were pulled from an original car as stated above. There is a TON of history here that I helped research when I...Liked On: 02-04-2016, 08:32 AM
Posted On: 01-07-2016, 10:26 PM
All times are GMT -7. The time now is 08:56 PM.





Likes Received