Club Cobra Gas - N Exhaust  

Go Back   Club Cobra > Members List
Reload this Page justcobra's Profile
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts


justcobra
CC Member

Last Activity: 11-14-2021 02:34 PM

About Me

  • About justcobra
    Zip Code
    3764
    City
    KILMORE
    State
    Vic
    Interests
    Car Restorations
    Country
    Australia
    Cobra Make, Engine
    Replica Motor Company
    Ride
    CORVETTES ETC
    Engine type and displacement
    5.4 dohc boss 260
    Tranny type
    Manual T3650 5
    Horsepower
    stock

Statistics

Total Posts
Albums
General Information
  • Last Activity: 11-14-2021 02:34 PM
  • Join Date: 06-13-2012

Likes Given

64 Likes
  1. justcobra
    justcobra liked post by DRB Sportscars On thread : DRB Sportscars, it all has to go!
    Each of our three cars; DRB Cobra (4 if you count the Boss Cobra), DRB GT40 and DRB540 are for sale. All of the jigs, tooling and IP for each of the cars is available for aspiring manufacturers. We...
    Liked On: 08-27-2020, 04:22 PM
    Posted On: 08-14-2017, 12:38 AM
  2. justcobra
    justcobra liked post by REPTYL On thread : Building a cobra
    Dug this up from the archives. I've spent a **** load since. But it was on the road for around $30k 02-May-97 427 Cobra body / Chassis $6,400.00 NEW 11-May-97 Rear end (diff)...
    Liked On: 03-02-2017, 02:52 PM
    Posted On: 01-27-2004, 09:58 PM
  3. justcobra
    justcobra liked post by Rob. Smith On thread : Newbie Seeking Advise - Cobra on a budget
    That RMC in a previous post looks pretty good....there's some good stuff in that package. My RMC cost 22 grand so there's a big start there. I'm afraid your buget might "escalate"a little. I...
    Liked On: 02-14-2015, 01:59 PM
    Posted On: 02-06-2015, 05:01 AM
  4. justcobra
    justcobra liked post by Modena On thread : Newbie Seeking Advise - Cobra on a budget
    Hi Greg, In short if you want to start a new build, your budget expectations are too low. If you want to build one of the better kits you're looking at 45+ to get it going, if you want a "nice"...
    Liked On: 02-14-2015, 01:58 PM
    Posted On: 02-04-2015, 03:21 PM
  5. justcobra
    justcobra liked post by d488y2 On thread : Newbie Seeking Advise - Cobra on a budget
    Welcome to the Forum. There's a couple of un finished projects on Ebay. AC Cobra RMC Series 3 Project in Kilmore, VIC | eBay...
    Liked On: 02-14-2015, 01:58 PM
    Posted On: 02-04-2015, 02:47 PM
  6. justcobra
    justcobra liked post by BAsque1 On thread : how tall ru and what make of car ?
    6'1" 260 lbs. see attached picture, it is worth a 1000 words. My Cobra is a WCC 6" longer and 4" wider, nuff said.
    Liked On: 07-19-2014, 03:24 PM
    Posted On: 07-09-2014, 08:18 AM
  7. justcobra
    justcobra liked post by Baz On thread : rmc torsional and beaming test
    Hi Dean, I built an RMC, starting in 2007. They are still trading as such as far as I know, but are also trading under the name of Westfiled Sports Cars. The address is the same at3/14 Fargo Way,...
    Liked On: 07-05-2014, 06:59 PM
    Posted On: 06-27-2014, 06:36 PM
  8. justcobra
    justcobra liked post by leroy17 On thread : Harrison #40 for sale (Aus)
    Thanks guys and I appreciate the feedback and comments. This was built by Paul (Ledge - past forum member) from Finch Restorations. Its not hard to search this forum to follow the build histroy...
    Liked On: 06-23-2014, 03:36 PM
    Posted On: 06-22-2014, 09:36 PM
  9. justcobra
    justcobra liked post by stiffy On thread : Harrison #40 for sale (Aus)
    deano59, Spend $60 on a QLD PO box and get a fantastic car........ See Cobra'sare easy to buy.........:p STIFFY
    Liked On: 06-23-2014, 03:36 PM
    Posted On: 06-22-2014, 10:41 PM
  10. justcobra
    justcobra liked post by BJ's Snake On thread : Evans Kit
    http://www.clubcobra.com/photopost/data/500/medium/nearly_finished_009_small.JPG Hi Busta First thing I suggest is to take your bank manager out to lunch and get to know him really...
    Liked On: 06-06-2014, 09:57 PM
    Posted On: 09-14-2006, 05:39 PM
  11. justcobra
    justcobra liked post by NASSTY On thread : Where did they all come from?
    I agree that suspension arms are not certified to ADR's. Instead an engineer will inspect them to make sure that they are safe. The easiest way to do this is to use a mass produced part such as the...
    Liked On: 06-06-2014, 09:34 PM
    Posted On: 09-15-2006, 12:26 AM
  12. justcobra
    justcobra liked post by stevehaygood On thread : Widening Jag Rear End
    That's great mickmate!! thanks very much, you clarified it just fine with me. Do you know anything a front end indie system with Jag xj unequal wishbone set up??? This one has me pretty stumped. I...
    Liked On: 06-06-2014, 09:17 PM
    Posted On: 01-28-2004, 08:28 AM
  13. justcobra
    justcobra liked post by Merv and Sharon On thread : Anaconda
    This may well be the car then Les? However the side pipes are not covered. Merv http://www.clubcobra.com/photopost/data/500/Mark2.jpg...
    Liked On: 05-27-2014, 04:26 PM
    Posted On: 12-28-2010, 10:12 PM
  14. justcobra
    justcobra liked post by Plums On thread : Another new person looking at kits.
    Here's my G-Force with Vintage Wheels in 17 x 8.5 with 235/45-17, and 17 x 10.5 with 315/35-17's... http://i39.photobucket.com/albums/e200/efitorana/GettingThere1.jpg ...
    Liked On: 10-15-2013, 03:18 PM
    Posted On: 07-30-2007, 03:46 AM
  15. justcobra
    justcobra liked post by deano59 On thread : Unfinished RMC in TAS
    $100.00 each way for a car trailer seems way to cheap .last time I raced down tassie it cost a hell of a lot more than that to get the tow car and trailer across now I know im talking both tow car...
    Liked On: 10-03-2013, 02:51 PM
    Posted On: 10-02-2013, 06:12 PM
Page 1 of 5 1 2345

All times are GMT -7. The time now is 04:38 PM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink