Club Cobra Gas - N Exhaust  

Go Back   Club Cobra > Members List
Reload this Page jimbo01's Profile
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts


jimbo01
CC Member

Last Activity: 03-31-2020 08:56 AM

About Me

  • About jimbo01
    City
    Tavares
    State
    FL
    Interests
    Flying and Building Cars
    Country
    USA
    Cobra Make, Engine
    Backdraft #832
    Engine type and displacement
    427 Ford EFI
    Tranny type
    5 S[eed

Statistics

Total Posts
General Information
  • Last Activity: 03-31-2020 08:56 AM
  • Join Date: 05-15-2014

Likes Received

41 Likes
  1. Ozzie Goat
    Ozzie Goat liked post by jimbo01 On thread : Electrical Issue
    Ron What I have been able to determine is that Backdraft uses a single ground wire to all the gauges. What gauge wire I am not sure. This is not according to VDO instructions. VDO says in...
    Liked On: 08-05-2022, 07:38 PM
    Posted On: 09-24-2014, 11:46 AM
  2. Ozzie Goat
    Ozzie Goat liked post by jimbo01 On thread : Electrical Issue
    Last evening I had the car running in the driveway. The water temp was up to 90 on the gauge which is normal. Then I turned on the headlights on low beam and the water temp gauge went up 10 degrees...
    Liked On: 08-05-2022, 07:36 PM
    Posted On: 09-23-2014, 08:16 AM
  3. ErikinSC
    ErikinSC liked post by jimbo01 On thread : Gas-N Exhaust
    After some time I received my new polished exhaust from Gas-n. Have to say the wait was worth it. These pipes are much heavier than the Backdraft ones. You can tell the quality is there. The...
    Liked On: 03-15-2021, 08:19 PM
    Posted On: 03-02-2020, 08:20 AM
  4. ErikinSC
    ErikinSC liked post by jimbo01 On thread : Knock off hammer
    A spanner wrench works best to remove the wheels. You would need the hammer to install the wheel. Depending on the wheel size you would need to modify the spanner wrench to fit the 18" wheels. ...
    Liked On: 01-31-2021, 09:38 PM
    Posted On: 03-15-2018, 01:35 PM
  5. BDR0572
    BDR0572 liked post by jimbo01 On thread : Gas-N Exhaust
    After some time I received my new polished exhaust from Gas-n. Have to say the wait was worth it. These pipes are much heavier than the Backdraft ones. You can tell the quality is there. The...
    Liked On: 12-12-2020, 08:56 AM
    Posted On: 03-02-2020, 08:20 AM
  6. ront49
    ront49 liked post by jimbo01 On thread : Replaced brake fluid
    Converting from Dot 5 which is silicone based to Dot 3 or 4 can be a real problem. I don't know who installed the Dot 5 in the car to start with. The system must be clear of any sign of the Dot 5...
    Liked On: 04-16-2020, 06:37 AM
    Posted On: 03-18-2015, 08:11 AM
  7. spdbrake
    spdbrake liked post by jimbo01 On thread : Gas-N Exhaust
    After some time I received my new polished exhaust from Gas-n. Have to say the wait was worth it. These pipes are much heavier than the Backdraft ones. You can tell the quality is there. The...
    Liked On: 03-02-2020, 09:57 AM
    Posted On: 03-02-2020, 08:20 AM
  8. brucest
    brucest liked post by jimbo01 On thread : Brake Booster
    Just received the booster today. Looks like new and half the price of a new one if you could buy it.
    Liked On: 04-29-2019, 04:12 PM
    Posted On: 06-12-2017, 12:09 PM
  9. BDR_Boy
    BDR_Boy liked post by jimbo01 On thread : Stopped for no brake lights !!
    I always carry a spare switch with me.
    Liked On: 05-22-2018, 03:42 PM
    Posted On: 05-22-2018, 02:39 PM
  10. mln385
    mln385 liked post by jimbo01 On thread : Backdraft tail lights!
    I removed the rear lights and front also. Ordered from Great Britian a complete set of Lucas lights to replace them with. Now I do not have the plastic inserts which is known to go bad. Took the...
    Liked On: 12-29-2017, 05:17 PM
    Posted On: 12-29-2017, 07:54 AM
  11. BDR0572
    BDR0572 liked post by jimbo01 On thread : Borla 8 stack injection
    Took a lot of work. The wiring harness purchased from Hollly did not fit and had to be modified. I guess it would have been better if i had purchased it from Borla. Maybe it would have had the...
    Liked On: 11-27-2017, 07:01 PM
    Posted On: 09-28-2017, 02:15 PM
  12. Quentin Z
    Quentin Z liked post by jimbo01 On thread : Brake Booster
    Just received the booster today. Looks like new and half the price of a new one if you could buy it.
    Liked On: 06-13-2017, 10:39 AM
    Posted On: 06-12-2017, 12:09 PM
  13. 6t8stang
    6t8stang liked post by jimbo01 On thread : Brake Booster
    Just received the booster today. Looks like new and half the price of a new one if you could buy it.
    Liked On: 06-13-2017, 05:49 AM
    Posted On: 06-12-2017, 12:09 PM
  14. Winchester67
    Winchester67 liked post by jimbo01 On thread : Brake Booster
    Just received the booster today. Looks like new and half the price of a new one if you could buy it.
    Liked On: 06-12-2017, 02:29 PM
    Posted On: 06-12-2017, 12:09 PM
  15. BDR0572
    BDR0572 liked post by jimbo01 On thread : Brake Booster
    The problem was finally solved. The shop in California can repair the ATE boosters. It is on the way back home. Sure happy not to have to change so many things. Talked with Mark and he is going...
    Liked On: 06-12-2017, 02:06 PM
    Posted On: 06-06-2017, 08:05 AM
Page 1 of 3 1 23

All times are GMT -7. The time now is 02:52 AM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink