Club Cobra GasN Exhaust  

Go Back   Club Cobra > Members List
Reload this Page Quentin Z's Profile
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts


Quentin Z
CC Member

Last Activity: 04-07-2025 09:30 AM

About Me

  • About Quentin Z
    Zip Code
    33132
    City
    Miami
    State
    FL
    Interests
    Cobras, Boating
    Country
    USA
    Cobra Make, Engine
    Backdraft #272, 351W
    Horsepower
    385
    60 foot time
    0.000
    1/8 Mile ET
    0.000
    1/8 Mile MPH
    0.00
    1/4 Mile ET
    0.000
    1/4 Mile MPH
    0.00

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. pm125
    02-08-2017 05:24 PM - permalink
    pm125
    I posted Cobra in Miami call me when you have a chance
    Pedro Capote 786-942-7068 Cell

Statistics

Total Posts
Albums
Visitor Messages
General Information
  • Last Activity: 04-07-2025 09:30 AM
  • Join Date: 10-22-2003

Likes Received

17 Likes
  1. Lucky275
    Lucky275 liked post by Quentin Z On thread : Can I remove these spacers under my seat?
    Mine only has the silver ones, maybe the PO removed the blacks ones on mine. My guess is that the silver one are probably needed to get clearance for the slider to work.
    Liked On: 02-27-2022, 08:10 AM
    Posted On: 02-22-2022, 01:05 PM
  2. Seanpatrick
    Seanpatrick liked post by Quentin Z On thread : Question about steering wheel shaking while driving
    Now that you mention it, when I first installed mine the DD shaft was set to far into the knuckle (that attaches to the rack) causing binding. I had to adjust the shaft, so that the knuckle could...
    Liked On: 11-29-2021, 07:25 AM
    Posted On: 11-29-2021, 07:14 AM
  3. Seanpatrick
    Seanpatrick liked post by Quentin Z On thread : Question about steering wheel shaking while driving
    You should consider this upgrade: http://www.clubcobra.com/forums/backdraft-racing/142572-steering-shafts-upgrade.html It adds a Borgeson Vibration Reducer. It won't help the 60mph steering...
    Liked On: 11-11-2021, 03:00 PM
    Posted On: 11-11-2021, 07:42 AM
  4. Bruce.huling
    Bruce.huling liked post by Quentin Z On thread : Fuel Tank Installation Plastic to Aluminum
    You definitely want to change the rubber connections! The fuel ate through mine and started leaking in a parking garage. Luckily the level wasn't too far past the bottom of the inlet, but messy...
    Liked On: 07-08-2021, 12:46 PM
    Posted On: 07-08-2021, 10:49 AM
  5. tennisbum132
    tennisbum132 liked post by Quentin Z On thread : Power Options for Accessories
    I mounted a motorcycle USB under the dash; similar to this one: ...
    Liked On: 02-25-2021, 10:01 PM
    Posted On: 02-23-2021, 09:59 AM
  6. Mattsvtcobra
    Mattsvtcobra liked post by Quentin Z On thread : Power Options for Accessories
    I mounted a motorcycle USB under the dash; similar to this one: ...
    Liked On: 02-23-2021, 08:55 PM
    Posted On: 02-23-2021, 09:59 AM
  7. BDR0572
    BDR0572 liked post by Quentin Z On thread : brake light on vrs pedal distance
    Do the lights come on when you touch the wire ends together?
    Liked On: 02-08-2021, 01:36 PM
    Posted On: 02-08-2021, 12:47 PM
  8. Mattsvtcobra
    Mattsvtcobra liked post by Quentin Z On thread : Tie Rod & Tie Rod Ends
    Today’s find: The rack and pinion boot for our rack is moog-k150272, Toyota Corolla 2003-2013
    Liked On: 06-07-2020, 05:24 PM
    Posted On: 06-07-2020, 01:57 PM
  9. Mattsvtcobra
    Mattsvtcobra liked post by Quentin Z On thread : Tie Rod & Tie Rod Ends
    Get the inner tie rod tool from harbor Freight for the inner tie rods: https://www.harborfreight.com/Inner-Tie-Rod-Removal-Set-63705.html You should consider the steering linkage upgrade that is...
    Liked On: 06-05-2020, 07:26 PM
    Posted On: 06-05-2020, 01:30 PM
  10. spdbrake
    spdbrake liked post by Quentin Z On thread : Tie Rod & Tie Rod Ends
    In case anyone is interested, I found that Moog EV239 tie rod works with my rack (car #272). It was +/- 5/16" shorter, but that worked better in my case. Also, BECK/ARNLEY 1013519 worked for the...
    Liked On: 05-29-2020, 06:03 PM
    Posted On: 05-28-2020, 10:16 AM
  11. Ozzie Goat
    Ozzie Goat liked post by Quentin Z On thread : Steering Wheel Quick Release
    I did not have to machine the OD. the hub was barrel shaped and symmetrical. I just had the outer taper cut off, so there was less gap between the hub and NRG receiver. I believe both wheels...
    Liked On: 04-30-2020, 01:22 PM
    Posted On: 04-06-2020, 02:29 PM
  12. FredG
    FredG liked post by Quentin Z On thread : Shocks......again
    I just installed the KYB KG5529 in car #272. You’re right, it’s the dampening that makes the ride improvement. Don’t worry about them being for a VW. It’s about the weight of car, not the HP. The...
    Liked On: 12-22-2019, 09:21 PM
    Posted On: 12-22-2019, 05:48 PM
  13. Peter T
    Peter T liked post by Quentin Z On thread : turn signal replacement
    You should be able to level the stalk with the dash (in resting position), so the tonneau will fit. The issue for me is keeping it there. It only stays tight for a while before it wants to start...
    Liked On: 04-01-2018, 02:37 PM
    Posted On: 11-15-2017, 06:56 AM
  14. Peter T
    Peter T liked post by Quentin Z On thread : turn signal replacement
    use: SWF W0133-1609437 (German) Try to search on partsgeek. I tried to post a link, but it somehow gets hijacked. Get the German made one. Unfortunately, the cheaper ones are garbage. I...
    Liked On: 04-01-2018, 02:37 PM
    Posted On: 11-14-2017, 03:55 PM
  15. Winchester67
    Winchester67 liked post by Quentin Z On thread : Wiring layout - earlier cars
    My car is #272; I created this wiring diagram in my spare time a while back: https://www.dropbox.com/s/rw3zrxszk3e3ena/BDR%20Wiring%20Diagram.pdf?dl=0
    Liked On: 06-01-2017, 03:56 PM
    Posted On: 05-10-2017, 01:48 PM
Page 1 of 2 1 2

All times are GMT -7. The time now is 01:43 AM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink