Club Cobra Keith Craft Racing  

Go Back   Club Cobra > Search Forums
Reload this Page Search Results
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts

MMG Superformance
Nevada Classics
Main Menu
Portal
Forums

Module Jump:
Nevada Classics
Nevada Classics
Keith Craft Racing
Advertise at CC
Banner Ad Rates
MMG Superformance
MMG Superformance
MMG Superformance
November 2025
S M T W T F S
            1
2 3 4 5 6 7 8
9 10 11 12 13 14 15
16 17 18 19 20 21 22
23 24 25 26 27 28 29
30            
Page 1 of 2 1 2
Showing results 1 to 25 of 49
Search took 0.03 seconds. Search: Posts Made By: DesertMK4
Forum: Arizona Cobra's 08-18-2021, 05:07 PM
Replies: 11
Views: 12
Posted By DesertMK4
FFR in Tucson

PM sent.
Forum: Holley Tuning 10-15-2020, 04:21 PM
Replies: 18
Views: 19
Posted By DesertMK4
Open plenum and if you have a spacer an open...

Open plenum and if you have a spacer an open spacer. Fuel float levels. Check jet sizes, mains and secondary may be mixed up. If it is down on power generally then its something bigger. My best guess.
Forum: Arizona Cobra's 08-21-2020, 04:29 PM
Replies: 8
Views: 9
Posted By DesertMK4
Arizona Registration.

I had a similar situation in Tucson. Very cursory. Mostly finding and verifying the chassis numbers. The inspection can be done on a flat bed. The engine was not run. They took about 10 minutes...
Forum: ALL COBRA TALK 07-29-2020, 04:01 PM
Replies: 23
Views: 24
Posted By DesertMK4
I used a sandwich thermostat that fits between...

I used a sandwich thermostat that fits between the oil filter and the side of the block. Be sure you have enough clearance at that point. Small block should fit. BB I don't know? Next, what is your...
Forum: Superformance 07-02-2020, 12:41 PM
Replies: 3
Views: 4
Posted By DesertMK4
Electric. Speed Hut can put on a Cobra logo for...

Electric. Speed Hut can put on a Cobra logo for just a few bucks more. Same front as FFR vintage set. Don't expect to see much movement. 306 Ford, oil cooler only heats up after some stop and go...
Forum: ALL COBRA TALK 06-24-2020, 04:45 PM
Replies: 11
Views: 12
Posted By DesertMK4
It all depends on what you are most comfortable...

It all depends on what you are most comfortable with. I have my FFR seats raised over an inch at the front. Some do it flat on the floor. Just be sure to use strong bolts into strong sections of the...
Forum: Holley Tuning 06-24-2020, 12:55 PM
Replies: 36
Views: 37
Posted By DesertMK4
Now I have a Holley 670CFM with vac secondary. I...

Now I have a Holley 670CFM with vac secondary. I see two things in your picture: no secondary idle mixture screw (the small lower hole on the base of the secondary float bowl). There is also one on...
Forum: Classic Roadsters II 06-21-2020, 12:53 PM
Replies: 37
Views: 38
Posted By DesertMK4
The most effective way to soften the ride is to...

The most effective way to soften the ride is to soften the springs. Shocks only dampen the motion. Sway bars only increase the spring rate when cornering. I dropped the spring rate from 550 to 450...
Forum: ALL COBRA TALK 06-19-2020, 12:27 PM
Replies: 52
Views: 53
Posted By DesertMK4
I used 4 friends. One on hoist, one on leveler...

I used 4 friends. One on hoist, one on leveler bat, two at sides, me all over the place. I lowered the front end of car so didn't exceed lift height and reach of hoist.. Rent or harbour freight. Must...
Forum: Classic Roadsters II 05-16-2020, 06:11 PM
Replies: 8
Views: 9
Posted By DesertMK4
Agree with springs settling in. Then to be fancy,...

Agree with springs settling in. Then to be fancy, measure with driver in seat and gas at established level. You may be surprised how much 300 lbs. can effect the final settings.
Forum: ALL COBRA TALK 04-04-2020, 04:55 PM
Replies: 3
Views: 4
Posted By DesertMK4
Trust the numbers not the colors

Springs are normally labeled with their spring rate (i.e. the amount of weight to compress the spring 1 inch). On an assembly line colors are used. A given model of car get blue springs, the big...
Forum: Weber Tuning 01-13-2019, 03:34 PM
Replies: 11
Views: 1,171
Posted By DesertMK4
Ford 302 timing

My motor from Ford Racing said 12 degrees BTDC at idle and not to exceed 36 degrees all in. The motor has a E303 cam as well. Please check your firing order for a HO engine. Should be 13726548 and...
Forum: ALL COBRA TALK 06-20-2018, 04:32 PM
Replies: 93
Views: 3,917
Posted By DesertMK4
I was in a similar situation three years ago. My...

I was in a similar situation three years ago. My solution was to build my own Cobra (FFR) and drive it with about twenty other retired guys. The build was a mental challenge, ate up a lot of spare...
Forum: FE TALK 01-27-2018, 10:24 AM
Replies: 21
Views: 1,366
Posted By DesertMK4
Jegs has a cam kit (about $15) which comes with a...

Jegs has a cam kit (about $15) which comes with a chart showing the amount of cam lift with each color of cam and some tuning tips. I have tried up and down the scale and landed on orange as the best...
Forum: Arizona Cobra's 10-20-2017, 03:08 PM
Replies: 14
Views: 800
Posted By DesertMK4
Dan: The Tucson Classic Car Show is that same...

Dan: The Tucson Classic Car Show is that same date. The Tucson Cobra Club is going up Mt. Lemmon on Sunday at 9:00am for brunch at the Iron Door. Sorry can't meet you guys at Lupe's
Forum: B & B Cobra's --- Speak with Bryan Anderson 10-18-2017, 11:11 AM
Replies: 8
Views: 2,980
Posted By DesertMK4
The Breeze rails I got (about 4 years ago) did...

The Breeze rails I got (about 4 years ago) did not have a tilt function, just a slide for and aft. I like a little rake to my seats so I put spacers (about 1 inch) on the fronts. Now I sit in the...
Forum: Australian Cobra Club 09-21-2017, 05:20 PM
Replies: 13
Views: 2,005
Posted By DesertMK4
FFR Mk4 front 500, rears 350. The front carries...

FFR Mk4 front 500, rears 350. The front carries the engine, radiator, etc. I changed out to 450 front and 300 rear. Removes much of the harshness and initial shock of even small bumps. Ford small...
Forum: Arizona Cobra's 02-22-2017, 10:46 AM
Replies: 5
Views: 742
Posted By DesertMK4
Carb tuning for Tucson

Most of us DIY. Depending on your carb you may need to adjust a step or two leaner in jets for Tucson altitude (2500 ft) above Florida's 0 ft. Look for the Holley web site that has lots of videos and...
Forum: ALL COBRA TALK 06-21-2016, 12:02 PM
Replies: 1,086
Views: 278,696
Posted By DesertMK4
Jet Fast Cobra

Which would you rather drive to work each day?
Forum: Arizona Cobra's 05-03-2016, 11:42 AM
Replies: 113
Views: 6,904
Posted By DesertMK4
Mt. Lemmon Run

The Tucson group just went up Mt. Lemmon on April 30. Not that it isn't a great drive every weekend. We do have a Cars&Coffee event on May 14, from 8:00 to 10:00, so May 21 may work better. Option #1...
Forum: ALL COBRA TALK 04-21-2016, 02:37 PM
Replies: 16
Views: 1,730
Posted By DesertMK4
Most MKIV owners use the bottom of the main frame...

Most MKIV owners use the bottom of the main frame rail to the ground as the measuring point. Most also set that distance at between 4 and 6 inches at the rear. I have used 4 1/2 to 5 1/4. My wheel...
Forum: ALL COBRA TALK 02-29-2016, 10:34 AM
Replies: 2
Views: 541
Posted By DesertMK4
Sandwich Oil Filter

I used an oil filter sandwich from Jegs. Worked great. Thermostatic opening. No need for adapter plate. A lot cleaner installation. 302 Ford in FFR roadster no clearance problems at all. :JEKYLHYDE
Forum: Classic Roadsters II 11-30-2015, 11:35 AM
Replies: 77
Views: 15,368
Posted By DesertMK4
Very interesting. Please send link to...

Very interesting. Please send link to M3Mike@hotmail.com
Forum: Arizona Cobra's 09-02-2015, 11:40 AM
Replies: 52
Views: 3,479
Posted By DesertMK4
Arizona Cobra T-shirts

[QUOTE=Bob Broberg SPF667 460BB;1360485][SIZE="4"] Got my two shirts today and check is in the mail. Great idea and thanks.:cool: They look great!
Price is as described: S-XL $16 XXL $18 plus...
Forum: Arizona Cobra's 05-04-2015, 03:48 PM
Replies: 11
Views: 967
Posted By DesertMK4
Where in Arizona? I have some Tucson shops.

Where in Arizona? I have some Tucson shops.
Showing results 1 to 25 of 49
Page 1 of 2 1 2

 

All times are GMT -7. The time now is 11:11 PM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink