Club Cobra Keith Craft Motorsports  

Go Back   Club Cobra > Search Forums

MMG Superformance
Nevada Classics
MMG Superformance
Main Menu
Module Jump:
Nevada Classics
Nevada Classics
MMG Superformance
MMG Superformance
Advertise at CC
Banner Ad Rates
MMG Superformance
Keith Craft Racing
November 2025
S M T W T F S
            1
2 3 4 5 6 7 8
9 10 11 12 13 14 15
16 17 18 19 20 21 22
23 24 25 26 27 28 29
30            
Showing results 1 to 20 of 20
Search took 0.01 seconds.
Search: Posts Made By: Jmar
Forum: Shop Talk 03-07-2004, 07:02 AM
Replies: 4
Views: 869
Posted By Jmar
I'm running low 12s and the local track wants a...

I'm running low 12s and the local track wants a six point cage. I went to another track and they told me that I just needed arm restraints. I have a single full width roll bar in the car now. If I...
Forum: ALL COBRA TALK 03-06-2004, 05:35 AM
Replies: 9
Views: 1,703
Posted By Jmar
I'm using a Holley 750 DP on my SBC (350) with a...

I'm using a Holley 750 DP on my SBC (350) with a cam similar to yours, 15 inches of vacuum at idle, an auto with a 2500 RPM converter at 2500 lbs. Yours should run well with 750 CFM.
Forum: ALL COBRA TALK 02-14-2004, 12:58 PM
Replies: 24
Views: 2,666
Posted By Jmar
It took me a long time learn that Mothers should...

It took me a long time learn that Mothers should be removed wet. The instructions say to let it dry but I save my arm and enjoy a nice carnuba wax when it's taken off before it's dry. Otherwise...
Forum: ALL COBRA TALK 11-05-2003, 07:51 PM
Replies: 19
Views: 2,363
Posted By Jmar
They installed 5-6 new ones at my school last...

They installed 5-6 new ones at my school last fall. I put one side over the curb and on the side walk to get clearance over some of them. I have and under -car exhaust so it's the part that rubs if...
Forum: ALL COBRA TALK 11-05-2003, 07:37 PM
Replies: 30
Views: 2,823
Posted By Jmar
I have two Trek 24 speed aluminum framed peddlers.

I have two Trek 24 speed aluminum framed peddlers.
Forum: ALL COBRA TALK 08-21-2003, 08:07 PM
Replies: 17
Views: 3,976
Posted By Jmar
Out here I can go to 2 tracks. The first track...

Out here I can go to 2 tracks. The first track tells me it's ok to go balls out if I have arm restraints. They actually have a tech inspection before I can go to the line and race.

The other...
Forum: ALL COBRA TALK 08-10-2003, 05:00 PM
Replies: 0
Views: 660
Posted By Jmar
My trac-loc expired, how to replace clutch packs?

I was at the strip and the left tire would not turn when heating the tires. Are there any tricks aside from sticking in a new clutch pack? Is it possible to add clutches or reduce the tolerance for...
Forum: Shop Talk 07-16-2003, 07:03 AM
Replies: 7
Views: 1,407
Posted By Jmar
Scott, Thanks for the info. I'm sure mine...

Scott,

Thanks for the info. I'm sure mine has a progressive rate link. I have been slowly tweaking my carb and have received mixed advice that my carb is too big for my application (750 dp), or...
Forum: Shop Talk 07-10-2003, 06:54 AM
Replies: 7
Views: 1,407
Posted By Jmar
Thanks guys. It sounds like I shouldn't mess...

Thanks guys.

It sounds like I shouldn't mess with it. I'm assuming that a stock 750 carb has a 1:1 ratio.

Jeff
Forum: Shop Talk 07-08-2003, 05:28 PM
Replies: 7
Views: 1,407
Posted By Jmar
Can you get these at a Holley parts dealer like...

Can you get these at a Holley parts dealer like Ramchargers or Summit? Does the new link seem to help throttle response?
Forum: Shop Talk 07-08-2003, 05:25 PM
Replies: 7
Views: 830
Posted By Jmar
There is a company that makes a swap kit for a...

There is a company that makes a swap kit for a 460 going into a Fox body car. If I remember, this was a while ago, the kit included the proper oil pan, headers and engine mounts. This was through...
Forum: ALL COBRA TALK 07-03-2003, 04:20 PM
Replies: 85
Views: 10,234
Posted By Jmar
I have 10:1 compression AL heads,36 degrees...

I have 10:1 compression AL heads,36 degrees timing and run 94 pump gas. No detonation problems. I could have gone up to 10.5 easily. Iron heads will be a little different since they retain...
Forum: ALL COBRA TALK 06-29-2003, 03:21 PM
Replies: 26
Views: 3,712
Posted By Jmar
I think most people that have the idea that our...

I think most people that have the idea that our cars are of lesser quality are not educated in our specialty. When somebody asks if it is a kit car I tell them yes and show them around the car to...
Forum: ALL COBRA TALK 06-20-2003, 05:34 AM
Replies: 3
Views: 717
Posted By Jmar
Sorry about rattling on. Think about the...

Sorry about rattling on. Think about the consequences when you drive over a rise in the road that lifts your car off the ground and the springs pop loose. I'm not talking about street racing either.
Forum: ALL COBRA TALK 06-20-2003, 05:29 AM
Replies: 3
Views: 717
Posted By Jmar
Sorry to contradict, but the vertical shocks on...

Sorry to contradict, but the vertical shocks on the Fox-body cars DID keep the springs in place. To remove the springs disconnect the shocks and pry out the springs.

Early model FFR Cobras used...
Forum: ALL COBRA TALK 05-05-2003, 05:40 PM
Replies: 1
Views: 1,076
Posted By Jmar
I've heard that it's best not to use synthetic on...

I've heard that it's best not to use synthetic on a new engine until you have a couple hundred miles on the odometer. I think it has something to do with allowing the rings to seat.

I broke in...
Forum: Shop Talk 04-26-2003, 05:18 PM
Replies: 7
Views: 1,346
Posted By Jmar
I think if you have the main bearing caps...

I think if you have the main bearing caps align-honed, the crank has been moved slightly toward the cam. This would change the relationship between the two and may slightly alter the cam timing.
...
Forum: ALL COBRA TALK 04-25-2003, 02:06 PM
Replies: 33
Views: 7,150
Posted By Jmar
They have a bad history. They scammed people in...

They have a bad history. They scammed people in the 80s before they were shut down by the attorney general - Many undelivered cars/parts. Their solution-change names and move to another location.
...
Forum: ALL COBRA TALK 04-20-2003, 08:04 PM
Replies: 44
Views: 3,932
Posted By Jmar
It's four-wheeled motorcycle that looks much...

It's four-wheeled motorcycle that looks much better than one! And you don't have to wear a helmet so you can enjoy the wind noise, exhaust music and singing tires.
Forum: ALL COBRA TALK 04-20-2003, 07:52 PM
Replies: 56
Views: 6,062
Posted By Jmar
Hi David! I had a problem similar to what...

Hi David!

I had a problem similar to what you described while using a 750 DP on my car. From what I understand, Holley DPs are meant to run rich since they are tuned more
for racing. My car...
Showing results 1 to 20 of 20

 

All times are GMT -7. The time now is 04:30 AM.


Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink