Club Cobra Gas-N Exhaust  

Go Back   Club Cobra > Search Forums
Reload this Page Search Results
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts

Nevada Classics
MMG Superformance
Main Menu
Portal
Forums

Module Jump:
Nevada Classics
Nevada Classics
MMG Superformance
Advertise at CC
Banner Ad Rates
Keith Craft Racing
MMG Superformance
MMG Superformance
May 2026
S M T W T F S
          1 2
3 4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21 22 23
24 25 26 27 28 29 30
31            
Page 1 of 4 1 234
Showing results 1 to 25 of 100
Search took 0.24 seconds. Search: Posts Made By: Dennis Kelley
Forum: Shop Talk 09-20-2008, 03:57 PM
Replies: 13
Views: 1,360
Posted By Dennis Kelley
2 times

Change in the spring and the fall. Whats another 50.00 bucks for the added sense of protection.
later
dennis
Forum: ALL COBRA TALK 07-22-2008, 07:39 PM
Replies: 51
Views: 15,388
Posted By Dennis Kelley
Spf

I've had both. SPF hands down. Both great cars but I know you get a lot more for your money with SPF. JMO
later
dennis
Forum: Small Block Talk 07-14-2008, 08:50 PM
Replies: 7
Views: 3,095
Posted By Dennis Kelley
Breather

Check that the throttle is not hitting the air filter base also. I had this to happen and it was a stupid little thing but it made the linkage stick and you didn't notice it with the breather off. ...
Forum: BackDraft Racing --- 07-07-2008, 03:53 PM
Replies: 35
Views: 3,412
Posted By Dennis Kelley
Run and Gun

Hey Guys,
I'm looking for info on the run and gun. Whats the link that give date time and place?
Thanks Dennis
Forum: Small Block Talk 05-23-2008, 01:29 PM
Replies: 9
Views: 1,026
Posted By Dennis Kelley
Retorque the water pump, intake bolt, and timing...

Retorque the water pump, intake bolt, and timing bolts. The bolts loosen up through heat cycles. I have had small leaks like this and a retorque has taken care of them.
Good luck
Dennis
Forum: Bay Area Cobra Club 05-22-2008, 06:04 AM
Replies: 13
Views: 1,625
Posted By Dennis Kelley
Cool video. Have any of you guys rode any of the...

Cool video. Have any of you guys rode any of the new Sport Bikes on the market. Lots of RPM's and a lot of fun.
later
dennis
Forum: Small Block Talk 03-26-2008, 09:18 PM
Replies: 39
Views: 8,547
Posted By Dennis Kelley
Mod Motors

I'm not a chevy guy but the LS series of engine is a much better design than the Ford mod. In my opinion the ford mod motor was a Turd in 1996 and is a Turd in 2008,
Forum: Small Block Talk 02-18-2008, 05:10 PM
Replies: 16
Views: 1,537
Posted By Dennis Kelley
The chassis dyno that I used had a wide band O2. ...

The chassis dyno that I used had a wide band O2. I would not go to a dyno that didn't have O2 sensor
Forum: Small Block Talk 02-15-2008, 04:10 PM
Replies: 16
Views: 1,537
Posted By Dennis Kelley
Chassis Dyno is a great tuning device. I dynoed...

Chassis Dyno is a great tuning device. I dynoed my small block and its amazing the difference in vehicles.
later
dennis
Forum: BackDraft Racing --- 02-13-2008, 03:59 PM
Replies: 3
Views: 1,232
Posted By Dennis Kelley
Is BDR still running the 3 Series bmw rear...

Is BDR still running the 3 Series bmw rear suspension on the gen 3?
Forum: ALL COBRA TALK 02-07-2008, 01:36 PM
Replies: 25
Views: 2,596
Posted By Dennis Kelley
Launch control is for people who don't know how...

Launch control is for people who don't know how to drive. Nice car I just don't want all the electronics. I wonder how many launches it will take before the Diff or tranny cries foul.
later
dennis
Forum: Small Block Talk 02-02-2008, 07:32 AM
Replies: 16
Views: 1,969
Posted By Dennis Kelley
IF it was me I would do a 4 inch stroke and 4.125...

IF it was me I would do a 4 inch stroke and 4.125 bore.
later
dennis
Forum: Small Block Talk 01-16-2008, 03:30 PM
Replies: 34
Views: 6,193
Posted By Dennis Kelley
If had both AFR165 and 185 and both of these...

If had both AFR165 and 185 and both of these heads where excellant performer and I thought reasonably priced for the performance gains. They like spray to.
Forum: Small Block Talk 11-24-2007, 06:31 PM
Replies: 33
Views: 4,435
Posted By Dennis Kelley
Holley

I'd do a 600 vac or dp. I have a 650dp on an afr headed small block 302. Rpm air gap intake. You can run a little bigger carb on a dual plane intake. Three Holley's in the last three years and...
Forum: Australian Cobra Club 09-23-2007, 05:32 AM
Replies: 5
Views: 726
Posted By Dennis Kelley
Ducati

I'm glad he won also. I love the Ducati motorbike. I'm getting ready to take mine out now. See ya.

later
dennis
Forum: Small Block Talk 03-28-2007, 04:58 AM
Replies: 1
Views: 1,137
Posted By Dennis Kelley
I have the same combo except cam is Crane 2030. ...

I have the same combo except cam is Crane 2030. It runs 298 RWHP on a Dyno Jet.

later

dennis
Forum: Small Block Talk 03-17-2007, 07:28 PM
Replies: 6
Views: 1,151
Posted By Dennis Kelley
Rpm

The reason for the bigger stroke than bore is that the engine master challenge only measure horsepower and torque up to 6500 rpm I believe. Its designed to limit the rpms by the rules set forth. If...
Forum: BackDraft Racing --- 02-09-2007, 09:35 PM
Replies: 29
Views: 3,234
Posted By Dennis Kelley
Car no 94

My diff has three bolts holding it in. two in back one in front. Again removing the rear diff in my car is a snap. I;ve had it out several times. I don't know if no.94 is an early car but I'm...
Forum: BackDraft Racing --- 02-04-2007, 05:52 PM
Replies: 29
Views: 3,234
Posted By Dennis Kelley
Cashburn correct me if I'm wrong but you do not...

Cashburn correct me if I'm wrong but you do not have to tap the diff if you get the E36 diff. If you buy the right diff it will have the mount hole already there. E30 diff did not have the front...
Forum: Small Block Talk 01-24-2007, 04:08 AM
Replies: 39
Views: 3,581
Posted By Dennis Kelley
M68 Hv

I run the above HV mellings pump no problems. Steel gear as per crane's recommendation no problem. MSD distributor hd pump shaft. I don't know why people take recommendations of what gear to run...
Forum: Fuel Injection & Tuning 01-20-2007, 04:40 AM
Replies: 5
Views: 1,856
Posted By Dennis Kelley
You will also need a 5.0 gt electric pump. All...

You will also need a 5.0 gt electric pump. All these parts are readily available in the U.S. cheap. Now is the time to make some friends and start shipping parts. Check some of the slavage yards...
Forum: Fuel Injection & Tuning 01-19-2007, 08:21 PM
Replies: 5
Views: 1,856
Posted By Dennis Kelley
Fi

Looks like basic 5.0 gt stuff which is good reliable stuff. Your missing the Computer, Mass air flow sensor, and the thick film distributor. Oh do you have the harness. Good luck

later

dennis
Forum: Small Block Talk 01-14-2007, 07:48 PM
Replies: 12
Views: 1,007
Posted By Dennis Kelley
what warren said. retorque intake or valve...

what warren said. retorque intake or valve covers never heads.
Forum: GT40 Talk 01-14-2007, 02:28 PM
Replies: 16
Views: 3,658
Posted By Dennis Kelley
GT 40 by Superformance is an awesome car. I...

GT 40 by Superformance is an awesome car. I might have to take a trip to see one of these.

later

dennis
Forum: Small Block Talk 01-11-2007, 07:04 PM
Replies: 2
Views: 815
Posted By Dennis Kelley
Heads

I would find out from Roush what type of pistons are in the motor. The AFR 205 probably will require piston notches. You might want to look at the 185's they have a 2.02 intake and a 1.60 exhaust. ...
Showing results 1 to 25 of 100
Page 1 of 4 1 234

 

All times are GMT -7. The time now is 02:39 PM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink