Club Cobra Gas - N Exhaust  

Go Back   Club Cobra > Search Forums
Reload this Page Search Results
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts

MMG Superformance
Nevada Classics
MMG Superformance
Main Menu
Portal
Forums

Module Jump:
Nevada Classics
Nevada Classics
MMG Superformance
MMG Superformance
Advertise at CC
Banner Ad Rates
MMG Superformance
Keith Craft Racing
MMG Superformance
December 2025
S M T W T F S
  1 2 3 4 5 6
7 8 9 10 11 12 13
14 15 16 17 18 19 20
21 22 23 24 25 26 27
28 29 30 31      
Page 4 of 4 123 4
Showing results 76 to 100 of 100
Search took 0.51 seconds; generated 87 minute(s) ago. Search: Posts Made By: cbreez
Forum: BackDraft Racing --- 09-25-2015, 06:09 AM
Replies: 47
Views: 6,171
Posted By cbreez
I have tracked my car hard on a full race course...

I have tracked my car hard on a full race course several times for several hours and found the car to be pretty good and about right. Funny, it's one of the few compliments that I have about a...
Forum: BackDraft Racing --- 09-24-2015, 06:40 PM
Replies: 47
Views: 6,171
Posted By cbreez
Why do you think that they are soft? What kind of...

Why do you think that they are soft? What kind of travel do you have? Do you know you your spring rates? These are light cars and don't need much tweaking.
Forum: BackDraft Racing --- 09-24-2015, 05:38 PM
Replies: 47
Views: 6,171
Posted By cbreez
Just curious, why would you want a stiffer shock...

Just curious, why would you want a stiffer shock for a cruising shock? What are you trying to accomplish?
Forum: BackDraft Racing --- 09-19-2015, 03:45 AM
Replies: 34
Views: 3,148
Posted By cbreez
I know what my Backdraft is, nothing from you...

I know what my Backdraft is, nothing from you needed...
Forum: BackDraft Racing --- 09-18-2015, 05:42 PM
Replies: 34
Views: 3,148
Posted By cbreez
Brakes? Maybe the pads... After the pedal went...

Brakes? Maybe the pads...
After the pedal went to the floor, I replaced a failed front caliper piston(O ring) that upon examination it showed the caliper was pressure washed, but not completely. So...
Forum: BackDraft Racing --- 09-18-2015, 06:09 AM
Replies: 34
Views: 3,148
Posted By cbreez
You are accurate! I have corrected some...

You are accurate!

I have corrected some problems from these salvaged parts. Always bothered me...It should be fully disclosed by Backdraft BEFORE a purchase. A good lawyer could run with this...
Forum: BackDraft Racing --- 08-29-2015, 06:51 PM
Replies: 14
Views: 1,748
Posted By cbreez
Pricey fluid and a lot of work...6 years...

Pricey fluid and a lot of work...6 years huh...seems it would be cheaper to just replace the 12-14 dollar slave cylinder when it fails...but to each their own.
Forum: BackDraft Racing --- 08-16-2015, 04:10 PM
Replies: 3
Views: 641
Posted By cbreez
Wow...Club Cobra helps you when you run out of...

Wow...Club Cobra helps you when you run out of gas...who woulda thunk it!
Forum: BackDraft Racing --- 06-26-2015, 06:39 PM
Replies: 11
Views: 1,083
Posted By cbreez
Before everybody blasts MSD...Did you check to...

Before everybody blasts MSD...Did you check to see if the rotor is spinning?

Coil??? Have you checked the box? There are simple tests that you can do...
Forum: BackDraft Racing --- 06-16-2015, 02:45 PM
Replies: 6
Views: 1,458
Posted By cbreez
What will you pay an owner to provide a test car...

What will you pay an owner to provide a test car for you're benefit???
Forum: BackDraft Racing --- 06-09-2015, 09:10 AM
Replies: 19
Views: 1,988
Posted By cbreez
Many threads on this...99% of the time the slave...

Many threads on this...99% of the time the slave is leaking. Leave the master alone and replace the slave with whatever it had on it and live with it till the next time. I find it's easier to refill...
Forum: BackDraft Racing --- 06-09-2015, 09:02 AM
Replies: 25
Views: 3,859
Posted By cbreez
Just sounds kinda funny to me, I guess that "flow...

Just sounds kinda funny to me, I guess that "flow resistance" is ok for racing though...right?

If you look at the size of crank oil holes and bearing clearances, you might rethink the whole...
Forum: BackDraft Racing --- 06-09-2015, 06:14 AM
Replies: 25
Views: 3,859
Posted By cbreez
427 or 289...have you even determined what your...

427 or 289...have you even determined what your oil temperature is running at before you worry about installing a cooler?

Installing a "dummy" for looks???

Increased flow resistance??? I guess...
Forum: BackDraft Racing --- 06-03-2015, 02:06 PM
Replies: 6
Views: 1,128
Posted By cbreez
Yup!!!! :LOL:

Yup!!!! :LOL:
Forum: BackDraft Racing --- 06-03-2015, 02:04 PM
Replies: 6
Views: 1,128
Posted By cbreez
.....

.....
Forum: BackDraft Racing --- 05-06-2015, 04:03 PM
Replies: 3
Views: 1,082
Posted By cbreez
It's really got to do with the spring rates, not...

It's really got to do with the spring rates, not really the tires...

RH should be measured from the frames rails to the ground on a flat, level surface. Factors such as fuel, driver, etc. need to...
Forum: BackDraft Racing --- 04-24-2015, 08:15 AM
Replies: 41
Views: 5,353
Posted By cbreez
I would recommend that you look very hard at...

I would recommend that you look very hard at good, used Cobras...there are plenty out there. They have been sorted, fixed and usually have low miles. Good Luck.
Forum: BackDraft Racing --- 04-04-2015, 06:11 PM
Replies: 16
Views: 1,989
Posted By cbreez
A leak down test will check valves and...

A leak down test will check valves and rings...not intakes and head gaskets.
Don't waste your time and the expense for a gauge.
Forum: BackDraft Racing --- 03-29-2015, 05:40 PM
Replies: 5
Views: 1,068
Posted By cbreez
I just make sure a good gasket is on there and...

I just make sure a good gasket is on there and you won't have a problem with a snug turn of the screw...I have the same.
If you really are still having a problem an easy fix would be a touch...just...
Forum: BackDraft Racing --- 02-02-2015, 01:49 PM
Replies: 17
Views: 3,035
Posted By cbreez
I think you need a new garage! :D PS: Some...

I think you need a new garage! :D

PS: Some of you may think that I'm being serious...
Forum: BackDraft Racing --- 01-10-2015, 05:41 PM
Replies: 33
Views: 4,610
Posted By cbreez
I see, you are here on this forum preaching but...

I see, you are here on this forum preaching but you really don't know how it works...Most folk here would like to learn how things work. BTW, I was just playing with you...I know how things works...
Forum: BackDraft Racing --- 01-10-2015, 09:03 AM
Replies: 33
Views: 4,610
Posted By cbreez
I did read the post...you still haven't explained...

I did read the post...you still haven't explained anything to all.

I think that what you portray is wrong regarding a recommended spring rate so explain it to us how that was determined other than...
Forum: BackDraft Racing --- 01-10-2015, 05:56 AM
Replies: 33
Views: 4,610
Posted By cbreez
Please explain your "math" that you used for...

Please explain your "math" that you used for determining racing spring rates. We all would love to know...
Forum: BackDraft Racing --- 12-12-2014, 06:47 AM
Replies: 15
Views: 3,168
Posted By cbreez
Don't waste your money replacing steering rack...

Don't waste your money replacing steering rack and parts as some have suggested, that's a typical knee jerk reaction to fix a problem with out knowing the cause, like our government does...throw time...
Forum: BackDraft Racing --- 11-25-2014, 09:06 AM
Replies: 1
Views: 716
Posted By cbreez
Yes, the other half of the velcro that supposed...

Yes, the other half of the velcro that supposed to be on the window. Just so you know, it should be under the flap...
Showing results 76 to 100 of 100
Page 4 of 4 123 4

 

All times are GMT -7. The time now is 02:47 PM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink