11-03-2002, 10:01 AM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Mar 2000
Location: St. Augustine,
FL
Cobra Make, Engine: E-M / Power Performance / 521 stroker / Holley HP EFI
Posts: 1,935
|
|
Not Ranked
Hi limebluie,
Here's a place to start.
Crane Cams failure tech page
Note the "Click for closeup" places - see if one of them matches the appearance of your dead cam & lifters.
Sorry it isn't more specific. Let us know if it helps any 
Regards,
Tom
PS: I've had cam failure too so I know what's involved - mine was a defective Ford crate motor distributor that ate the gear off the cam...
PPS: Also, as to the lifter bore angle, the site says "or the angle of the lifter bore is not 90 degrees to the centerline of the cam" - the inference is that 90 degrees is the correct angle.
__________________
Wells's law of engine size: If it matters what gear you're in, the engine's too small!
Last edited by Tom Wells; 11-03-2002 at 10:04 AM..
|
Hybrid Mode
