|
Driver side valve cover gasket
I've replaced, loosened, tightened, changed breather, everything, but can't get the valve cover to stop leaking oil. Drivers side, outside over the plugs, back corner. It' just enough to drip down the backside, and either run down the front of the bell housing or get wind whipped to the side wall and lower firewall. Then the wind carries it down the frame or under the floor pan where it drips a healthy amount while it rests in the garage, or my brand new trailer floor. A healthy amount is: I've added one quart since November. And I've driven quite a bit.
Any suggestions? |
Sounds like a bent or warped valve cover.
Have you put a straight edge on it ? |
| All times are GMT -7. The time now is 09:03 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: