|
FS: Freshly rebuilt HEH-BW Toploader
I'll have an HEH-BW Toploader ready to go by the middle of next week. It's a wide ratio, 1-1/16x10 input, 28 spline output. It will have new blocking rings, SKF bearings, countershaft pin, seals, snap rings, needle bearings, etc. I'm also replacing the input shaft bearing retainer and 3rd gear. I can set it up with either a 6T or 7T speedometer gear. It will be cleaned, painted, and ready to roll.
The casting numbers for the case and tailhousing are: RF C5AR-7006-D (8 hole case) and C4ZR-7A040-A. $839 + shipping. All work is done by me, so you know where you can find me. I'm also a dealer for Hurst and Long, so I can order and install a shifter at your request. |
| All times are GMT -7. The time now is 11:24 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: