Club Cobra

Club Cobra (http://www.clubcobra.com/forums/)
-   ALL COBRA TALK (http://www.clubcobra.com/forums/all-cobra-talk/)
-   -   Electric fan wiring. (http://www.clubcobra.com/forums/all-cobra-talk/106093-electric-fan-wiring.html)

duffer 08-10-2010 04:45 PM

Electric fan wiring.
 
I've been wanting a Cobra since the sixties. I finally bought a Classic Roadsters 427 SC a few weeks ago. It was supposedly completed in 1991. I love it, but it has a few issues. I had some work done on the distributor and carb. After I got it home I found the fan no longer works as it did before the work was done. It has a thermostat controlled circuit, a manual switch on the dash , and a wire that when attached to the terminal on the fan, makes the fan run all the time. Now it runs all the time, even with a cold engine. Anyone out there have a circuit diagram, or advice? The terminal strip on the left side of the fan has 4 terminals. From top to bottom they are labelled +, G?, M, and C. I'd appreciate any advice.

Wbulk 08-10-2010 05:51 PM

The fan normally turns on when the fan relay is grounded causing current to flow through the relay to the fan. The ground is usully accomplished by the fan thermostat reaching the desired temp and then grounding, or a manual switch to turn on the fan going to ground.
Did you check to see if when they worked on the car they turned the fan thermostat knob. You can set those down to about 38 deg. I think. So, it would be on even when cold. Other than that check your two grounds one on the fan thermostat and the other that goes to ground from the manual switch.

Wayne

duffer 08-15-2010 07:42 PM

Thanks - I'll take a look in the morning. I've been busy trying to get a new Holley dual feed to stop leaking gas all over the engine!

IndyCobra 08-17-2010 09:54 AM

Go to Summit Racing and search on the Painless wiring kit for a fan relay. If you click on that part for more detail, you can pull up the wiring instructions which include a diagram.

Skuzzy 08-17-2010 10:42 AM

Unless Painless has modified it, thier drawing will not show how to wire in a manual override switch for the fan.

I had to modify the circuit diagram for a car I helped wire up recently, as he wanted a manual override for the fan as well.

It is a ground activated circuit, which throws a lot of folks off the trail.


All times are GMT -7. The time now is 09:46 AM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: