|
need advice on jacking bridge 4 post
Hey all,
I am looking to get a jacking bridge for the 4 post lift. The jacking bridge uses 2 bottle jacks to lift the car. If I purchase the bridge with the jack, I will be at half the cost of the wheeled jacking bridge that works with the lift. Any suggestions? I was looking at 2 air bottle jacks, but was thinking for more money I could get a more stable system. Thanks |
couple things you need to be very careful about--4 posts lifts are designed to support the load at the cross over aligned with the posts and some lifts are designed with'for the bridges you talk about, however not all are and adding a cross piece to use as support for a couple of jacks to lift a vehicles weight at some other point could be disasterous--
|
The lift I am looking at sells the jacking bridge to do this purpose. In addition they also sell the bridge for manual bottle jacks.
But thanks hor the heads up I will definitly ask this question when purchasing either. |
The lift I am looking at sells the jacking bridge to do this purpose. In addition they also sell the bridge for manual bottle jacks.
But thanks for the heads up I will definitely ask this question when purchasing either. |
I use jack stands to lift tires off ramps if 2 post has something on it. I lift only one end of coarse. I have the cross jack platform but don't use as much as jack stands. I have a set up to 24" and a set up to 60". Two post is better for most things but I park cobra on 4 post to protect car. Bendpak 4 post ,Mohawk 2 post.
|
razerwire,
So, the runway has enough space to place the jack stand on with out the bridge? The runways that I am getting are 20 inch wide. I have noticed typical 4 post are 18 inch. With this being said, do you think I could get away with not purchasing the bridge right now? |
razerwire,
So, the runway has enough space to place the jack stand on with out the bridge? The runways that I am getting are 20 inch wide. I have noticed typical 4 post are 18 inch. With this being said, do you think I could get away with not purchasing the bridge right now? |
I put the jack stands on floor under the frame and then lower the rack to raise the tires. I pick what height I want the car when I'm working on it, then adjust jack stands under frame and lower hoist enough to clear tires.
|
| All times are GMT -7. The time now is 01:00 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: