|
Looking for a Hayward wiring diagram
Does anyone have or know where to find a wiring diagram for the cobra from Hayward?
This cobra build uses a Hayward wiring harness. We are having a problem with brake lights and found a short to ground. However now the front parking lights come on with the brake lights. This particular wiring harness uses 4 relays for to control what appears to be the hazard lights. One relay for each light (front right, front left, rear right, rear left). Between the rear light relays and the front light relays appeared to be a diode that got melted. A wiring diagram would help us understand if that was a diode or fusable link. Does the Painless wiring harness also use a bank of 4 relays? If so, maybe a painless wiring diagram could be used to help us solve the problem. Suggestions? |
Do you mean Haywire? If so, call Ken and I am sure he'll help you out.
Or if you are coming to the rally in San Marcos this weekend I can bring mine and you can make a copy if it looks like it will work. Jim |
Yes Jim, I will be in San Marcos, Thursday, Friday and Saturday. If you could bring yours that would be great. This is for Greg's H. car.
This would be great, thanks. |
Quote:
|
Thanks guys.
|
FYI the Haywire wiring harness will likely not tell you what you want to know about that diode or fusible link, I don't think either existed in the harness when new. We can take a look in SM tomorrow (Dusty from Hurricane will be there too) but the only diodes I know of were installed later by the owners to block current flow from feeding back from the front headlight low beam circuit into the high beam circuit. The harness didn't come with them. Gregg, when do you arrive?
|
I remember installing diodes on the turn signals so the current wouldn't feed all four parking/turn signal lights at one time, but my memory is a bit foggy about the high beams/low beams.
Manual check: Page i28 in the Hurricane instructions says, "wire to each turn signal wire, a 1 amp diode using a butt connectiors or solder. Connect so that the triangle on the diodes will end up pointing towards the lamp". the diodes stop the current from flowing to all four signal lights at one time. Get the diodes t Radio shack. Bill |
| All times are GMT -7. The time now is 08:53 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: