| wrench87 |
03-28-2012 05:29 PM |
holley ultra hp aluminum and turkey pan
does anyone know if the holley ultra hp carbs in aluminum fit inside a turkey pan?, i think there fuel bowl design is a little different.
|
| wrench87 |
03-29-2012 05:37 AM |
does anyone know what the length of turkey pan?.
|
| patrickt |
03-29-2012 08:22 AM |
I don't think the length is going to be your problem (if you have any problem at all). The width could be tricky because you have your linkage to add in. My TP was custom fabbed for me, so it might not even be "stock" but you can see the additional room I have even with the Holley 3310 in it (which only has one block). If it were me, I'd just order the carb you want from Summit and if it doesn't fit just ship it back to them.
http://www.clubcobra.com/photopost/d.../turkeypan.jpg |
| wrench87 |
03-29-2012 02:44 PM |
i think the ultra hp is a little over 14" long, do you know how big theturkey pans are?. i finally pulled my 342 engine and efi harness just sold it today so now i can install my 445 fe.
|
| mybluecobra |
04-01-2012 01:45 PM |
I have a Holley 950 ultra aluminum carb and it will fit in a Turkey pan.
You will have to widen the two fuel line openings in the bottom of the pan since
the Ultra Holley float bowls are larger, and therefore the distance between the two fuel lines is about 3/4 inch wider. You may also need to modify your fuel line setup for the increase in spacing between the front and rear float bowls.
|
| All times are GMT -7. The time now is 01:14 PM. |
|
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link:
