|
Need help fabricating exhaust system
I need some guidance on how to route the 3" tubing where it transitions to the engine. The pass side looks relatively straightforward. The the driver's side has the master cylinders..
Thanks Bill D |
hi Bill, that's the problem with under floor pedals, packin' 10lbs of s++t into a 5 lb bag, there just ain't much room down there, you gotta run between the 4" main frame rail, and the 1st master cylinder, under the other 2 past the outter frame rail and then onto the side pipes, Spintec probably has what you need- Oval Tubing - Oval Elbows - Vertical Oval Elbows - SpinTech Performance Mufflers
|
| All times are GMT -7. The time now is 07:41 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: