Retro fitting a CSX rollbar on a superformance

Three Peaks · #1 (**permalink**) 12-17-2014, 06:56 PM

Bernica,
What diameter tube is your roll bar? It looks like 1 3/4" like mine and I've been looking for trim rings like those for mine and struck out. May have to machine my own if I can't find a source.....

Bob

Bernica · #2 (**permalink**) 12-17-2014, 07:07 PM

Quote:

Originally Posted by Three Peaks

Bernica,
What diameter tube is your roll bar? It looks like 1 3/4" like mine and I've been looking for trim rings like those for mine and struck out. May have to machine my own if I can't find a source.....

Bob

I believe I got them from Finishline. It's been many years. I will check on diameter, but I believe it's 1-3/4". It's a CSX 4000 car. I can tell you that fastening the rear escutcheon was quite a chore to get it right.

Three Peaks · #3 (**permalink**) 12-17-2014, 08:32 PM

Quote:

Originally Posted by Bernica

I believe I got them from Finishline. It's been many years. I will check on diameter, but I believe it's 1-3/4". It's a CSX 4000 car. I can tell you that fastening the rear escutcheon was quite a chore to get it right.

Thanks, if it is a CSX 4000, it is 99% sure these are 1 1/2" roll bars. Thanks anyway.

Bob