|
Backdraft half shafts
2 Attachment(s)
Half shafts removed. Car built on December 2011. Had bolts holding shafts in so I assume later ones? I was told nuts for the earlier years. These look thick to me but obviously not thick enough. About to send them off to driveshaft shop for rebuild.
|
It would be interesting to know what the OEM fitment was on the those later model BDR axles. They look like Audi Quattro fronts. No tone rings and overall size. https://www.ecstuning.com/b-feq-part...n0407271e~feq/
Hopefully DSS can narrow that down, as BDR has never divulged the fitment on the later axles, just that the early cars use E36 axles which are a direct bolt-up. Also I'd ask DSS if the failure is contributed to the necked down areas of the axles as they pass thru the boots. (Beefed up center section transmitting the load to the ends). The only other Achilles issue on the later BDRs is the Integral rear hub. Instead of a E36 hub with a bolted on pin drive adapter they made their own One-piece Hub/pin drive assy. If you look at the pics in the thread below, the splines end at the outer hub. The twisting torque is being transmitted to the bearing area of the hub and not the outer portion where all the shear load is. There have been instances where they shear off. Luckily the brake has kept them from exiting the fender well on the ones I've seen. http://www.clubcobra.com/forums/back...drive-hub.html But BDR evidently has corrected that issue on the latest revision. I don't know the Build # it started at. (Change is mentioned in the next to last post in the thread.) |
Just make dam sure you use red Locktight when installing the flange bolts.
|
| All times are GMT -7. The time now is 08:15 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: