| Cobra 29 |
06-12-2021 05:46 PM |
For leak free connection
I am installing a new electric fuel pump. All connected gas lines and electrical wires. After starting I have a very slow leak on the outlet side. I probably need to reseat the brass 3/8 fitting into the aluminum fuel pump block. What should I put on the threads for a leak free connection. I am using teflon tape now but maybe not enough. Teflon tape, pipe dope or something else?? Thanks
|
| patrickt |
06-12-2021 06:16 PM |
|
| talos |
06-12-2021 06:34 PM |
Sealant
|
| MOTORHEAD |
06-13-2021 09:29 AM |
I've had good luck with "Permatex Thread Sealsnt with PTFE" p/n 80632.
|
| All times are GMT -7. The time now is 06:09 AM. |
|
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: