|
Adapting bumper to Quick Lift
2 Attachment(s)
I bought these quick lifts from @Shell Valley. Upon receiving them I noticed that my tubes and screws for my bumpers are at 3 3/4 inches but the bolt holes for the quick jack are spaced only at 2 1/4 inches?
Is there a company that makes these at 3.75” spacing instead of 2.25”? Is there some adapter plate that is made? I understand if these are the only two sizes and I don’t know who makes one for the larger 3.75”? Transition there’s no. I would buy a hunk of steel and machine these myself, if I had the equipment, but I don’t. Attachment 38359 Attachment 38360 |
I would plug the holes with shrink fit plugs and re-drill at new centers, larger washers could then be used to cover the plugs.
|
| All times are GMT -7. The time now is 08:40 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: