|
headers and sidepipes ad nauseum
Didn't get any response when this was posted on the Tech board, so I'll try this.I'm starting to check out various sources for the headers and sidepipes on my Kirkham. Does anyone have the phone number and/or email for Drew Serbs? David Kirkham also recommened Justin O'Rourke, RI. Anybody had any experience with him? E-mailed Tom's but have yet to hear from him.
Also, other than cost, is there any reason not to use ceramic? Any recs for that job? Thanx again. Feel free to email me privately, or in the forum. thanx steve meltzer, |
My pipes are not coated, I like the look when they get all heated up and "used" looking and can always ceramic coat later. I would highly reccommend coating your headers though - it is a must for the amount of heat these motors produce...Plus it is allot easier to do before they are installed - getting them out after putting them on the motor is a b!tch...
|
Steve:
Do NOT coat your headers and sidepipes before you have fitted them and are satisfied with their fit and function. Granted it is a pain to fit them and then remove them for coating and reinstall, but you will be glad you did. Pipes will "settle in" after a few cycles of heating and cooling, and it is a good idea to let that happen before you do any coating. Most coaters don't care if the if the pipes have had several hours of use through them anyway...process is the same. Bud:JEKYLHYDE :JEKYLHYDE :JEKYLHYDE |
A
delete
|
| All times are GMT -7. The time now is 02:46 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: