
12-31-2003, 11:39 PM
|
|
CC Member
|
|
|
Join Date: Nov 2003
Location: Sacramento,
Posts: 110
|
|
Not Ranked
I can't recall what I paid. I do know it is only 6" long. The engine
placement is set back 10" from the norm. And I remember not paying attention to detail and spilled the needle bearings all over the floor. Your town probably has a few places that will cut to fit a drive shaft for you. I think I ended up with about 3/4 of an inch of yoke travel. That might not be the optimum slack but that is what I ended up with.
__________________
Butler Racing Inc. 058
|