|
Trigo brake caliper clearance
I am finally about to order 15" Trigo wheels after much procrastination but it would make me feel easier if I could get some feedback on these parts if anyone has similar setup:
Running wilwood circuit use 12.19" X1.25" rotors Wilwood billet superlite calipers Caliper is mounted approx 2mm inside wheel mounting hat bolt face, or where adapters will bolt to! Not a biggy but if I order two sets of wheels it would be a pain if they didn't fit. |
This page will help. ERA wheel offsets
Our wheels are "standard" OEM pin-drives with about 3/8" machined from the mounting face, so there should be over an inch clearance where the drawing says 0.8". |
| All times are GMT -7. The time now is 03:16 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: