|
Shell Valley on an FFR Body Buck
Has anyone used the FFR plans to build a body buck for their Shell Valley? Did it work? Any suggestions? I have the lumber here today and I'm about to begin.
Thanks in advance. Tim |
Roxie,
The FFR plans don't even fit the FFR contours, so with a double strip of HVAC large foam insulation stapled to it it should get close enough to support it fine. On the Shell valley be sure and support the rear bulkhead arc and the dash cowl area, you don't want it to take set at the wrong arc. You don't want to get a case of "perky butt". grumpy |
yes
|
4Y?
|
| All times are GMT -7. The time now is 11:32 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: