|
Garage Floor
I know, thousand times before...
However I seek info on "U Coat It" product heavily advertised in the glossies. Specifically, any one with a year or two of use/abuse, your experiences and likes/dislikes. If it works as they hype it, it ain't bad for $250. To good to be true??? Thanks for any insight. |
Quote:
|
I used Ucoat it on my garage floor and could not be happier with the way it turned out. It went on easily and held up to anything I could throw at it, oil, grease, brake fluid, rolling floor jacks and engine hoists, snow, road salt, etc. After 3 plus years of use and abuse it never so much as showed a scratch. I would highly recommend it.
However, one point, I used it on a brand new concrete slab, so I cannot speak to how it holds up if being applied on an old slab or over an older floor paint. |
I did mine four years ago on a twenty-five year old garage floor. It wears like iron and still looks great. Don't scrimp on the prep work. I highly recommend it.
I even put it on the floor of my trailer. I wasn't sure how it was going to work on plywood, but it came out great. |
I used Rustoleum Epoxy Shield on the garage floor 4 years ago. Looks great.
I think I paid 150.00 for all the materials but spent a day preparing the floor. Commercial companies cost alot but are superior with the oil base paint and warranty. John |
A friend of mine used something called "muscle gloss", he got it from their website. He really liked it. I haven't seen it in a while, but saw it about a year after application and it still looked great.
|
I do garage floors for a living, and I hear stories all day long about failed DIY floor coatings. The reason most fail is the prep work, or more specifically, the lack of prep work.
We use a diamond carbide floor grinder and remove about 1/16" of surface to physically remove stains, wavy finish work, pitting, etc. By using that method, we avoid adding moisture to the concrete, which is what happens when you acid etch a floor. The grinding and blasting also removes small fractures which eventually become pitting and spalling. A shot blaster does virtually the same thing, but results in a more uneven surface. Our professional coatings are also superior to a cheap homeowner product, but IMHO its the prep that really makes the finish last. Good luck with your floor. |
Thanks to all-that's just what I was looking for.
Special thanks to Remod-great to know what goes into a professional job and appreciate the tips. If you were closer to the Atlantic Ocean I would hire your company. I hear you all about prep. Thanks again. |
| All times are GMT -7. The time now is 01:13 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: