|
Father's Day?
Are there any runs being planed for Father's Day?
Mother's Day was a blast and I was hoping repeat the experience on June 20th. Also, I heard the rumblings of a dyno day in June. Is that still happening? -Madik- |
I'm in
Its starting to get pretty warm.....if you guys plan a run up to cooler country count me in. Im a new father and I cant think of a better activity on fathers day than a Cobra run!!!!.....Scott:3DSMILE: :3DSMILE:
|
I do not have anything planned for that day.
I'll be out of town then. Check with Mr. Pink he may schedule something say to Flagstaff. A good run would be to Lake Mary/Mormon lake area. Mike |
Alright, so Scotts in... any others? North is the plan, but someone needs to pick a route.
-Madik- |
| All times are GMT -7. The time now is 03:25 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: