Club Cobra

Club Cobra (http://www.clubcobra.com/forums/)
-   Australian Cobra Club (http://www.clubcobra.com/forums/australian-cobra-club/)
-   -   AU Rear Control Arm Bushes - Top & Bottom (http://www.clubcobra.com/forums/australian-cobra-club/103238-au-rear-control-arm-bushes-top-bottom.html)

Sloth 03-07-2010 10:36 PM

AU Rear Control Arm Bushes - Top & Bottom
 
Anyone know where you can buy these less than at Ford? I was quoted about $130 per bush today. The rubber seal around both ends on all four outer bushes has perished, exposing the sticky stuff inside (and no doubt what that sticky stuff is lubricating) to the elements. It may be a long shot but one i have to try at around $520....

Thanks

Stuart

Philm 03-08-2010 01:41 AM

HI Stuart,
Not sure if there is an alternative, I tried 2 years ago and there was nothing but original.

As you say I am just starting to walk properly after buying a complete rear end set from Ford.

However they do make a huge difference.

Phil

Mando 03-08-2010 03:43 AM

Are you referring to where the rear upper and lower arms connect to the chassis? I bought and installed all new bushes before deciding to make new ones from scratch. If these are the ones you need let me know they may still be at the fabricator, if he didn't dump them!

Regards.

Sloth 03-08-2010 12:55 PM

Mando, alas, they are not. I refer to the outer ends.

Stuart

Aussie Mike 03-08-2010 03:30 PM

They use a spherical bearing in there packed with grease and a rubber boot to keep the dirt out. I reckon leave them as they are. If there is no play in them just drive it and replace them in 20,000KM when they start to wear. Even if the boots are perished they should still be OK. There's plenty of cars on the road running rod end with the bearing exposed to the elements.

Ford in their wisdom used a non standard spherical bearing size, a part unique to the AU rear end. I reckon it was a commercial decision. design a part that fails a few years out of warranty and then they rape you on the replacement parts. Sounds like good business to me.

I dumped the whole setup and built this...

http://www.clubcobra.com/photopost/d...spension_1.jpg


All times are GMT -7. The time now is 09:05 PM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: