Steering Wheel\Boss ADR approved

[suthol]

Originally Posted by Zedn

RMS have been quite good on this one. They are accepting ADR10/01 so pretty much any saas or autotecnica. Just check you can get the certificate for the model before purchase. I have email address for autotecnica MD.

I got through in May this year with an AutotecnicA wheel and boss, I asked for and received supporting information from Tony Vita the MD of AutotecnicA Imports.

Tony's advice was that all wheels & bosses had been tested but not all combinations and this was accepted by both my engineer and the RMS.

Note: this was submitted under the old scheme when times were tough so I expect that this would still hold true given that the VSCCS online system for the engineers contains a directive to use ADR10-01 ( Treeve could confirm )