|
Seat belts and seat mounts
Hi all,
Does anyone know the part numbers for their seat belts? Also how have you attached the storks to the chassis and in what position? Also seat mounts? Any pics would be greatly appreciated. Happy new year to everyone Stan. |
Stan
My belts are Klipan K6254 Doug |
Depends on what type of setup you've got. Some reels are located in the boot while some others go between the seat and tunnel.
Regards. |
Gday Stan,
You can see my mounts in the walk around video i posted in my progress thread below. I made a small frame to mount the seat belt retractor inside the boot. It bolts through the body and into some mounting brackets i welded on the chassis. I welded in some additional cross members to bolt seat mounts and seat belts to. The NCOP VSB 14 provides guidelines for designing your seat mounts and you should also discuss with your engineer. Most seat belts use 7/16 bolts which will come with the belts. The seat belts part numbers can be found on the Klippen website. It all depends on the seats you use and the location you mount the retractor. The locking mechanism is different depending on the angle it is mounted. You can get vertical, horizontal and in between. The stalk length will depend on your seats. You need a stalk that places the buckle approximately at your hip so hence the seat height will make a difference. Send me your email address by PM and i will email you a document i prepared for my engineer. It includes photos of each mount and dimensions. Since our chassis are very similar you can probably do the same. Happy new year. Liam |
stan i've sent you some pics so check your email & ring doug p & he will tell you what to do as he did mine as you know
|
Quote:
Its dependant on your mount location. Look at this link: http://www.apvsafetyproducts.com/wps...088eae1920d9f6 I used the original buckle from the MX5 seat (and its mount) and a K6274 (without the buckles). I made the reel mount, and its level with the floor. Note that the angles need to be within 2 deg for them to work. Oh yeah and standard length. Nathan |
| All times are GMT -7. The time now is 07:23 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: