Club Cobra

Club Cobra (http://www.clubcobra.com/forums/)
-   Australian Cobra Club (http://www.clubcobra.com/forums/australian-cobra-club/)
-   -   Wiring harness (http://www.clubcobra.com/forums/australian-cobra-club/63562-wiring-harness.html)

boxhead 04-16-2005 10:02 PM
Wiring harness
 
For those guys who have done or are doing there own wiring harness, where did you source your terminals from?

I am not going to use indivdual bullet or spade terminals at each connection and want to buy 2, 3 4 etc pind connector blocks, where can I find them?

I have some large 15 - 20 terminal connectors for passing through firewall and rear bulkhead but cant find a source for smaller connectors.

On the same subject, I realise that most of the wire harness kits are probably from the states, do you have to modify in any way since we use indictaor light instead of flashing brake light?
And do the harness's normally have an earth return built into the light systems?

Barry Nelson 04-17-2005 12:10 AM
Boxhead
I can help you with your 2,3,4,6 pin plugs
they can be scorced from a motorcyclr shop in the Alice if you wish to call me on 0418538264 I can give you the details
Regards Bazz

boxhead 04-17-2005 12:17 AM
Thanks Barry, calling now.

trularin 04-17-2005 06:01 AM
Terminal Supply, Troy, Michigan.

They carry Packard weather seal and GM spec connectors, wire seals and wire.

Sorry, don't have a number.

boxhead 04-23-2005 05:14 PM
I have ordered all the terminals I think I need, no doubt I will be back there to get more.

Thanks for the tip Barry.

Barry Nelson 04-24-2005 06:38 PM
Boxhead, pm your address. I'll send you a
catalogue on all parts you may be able to use.
Regards Bazz.


All times are GMT -7. The time now is 04:36 PM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: