|
Would this work?
Hey there everyone, just looking for some input on a subject.
Check out this and let me know what ya thing? http://cgi.ebay.com.au/ws/eBayISAPI....MakeTrack=true Can someone measure there oil cooler and tell me if this one is close to the right size? Also do you think it will be able to fit my engine? I realise the hoses look kinda cheap and maybe it is cheaper to buy the pieces indivdually and get some better quality hoses, just looking for thoughts. Thanks After looking at more ebay stuff I also found this one http://cgi.ebay.com.au/ws/eBayISAPI....545457706&rd=1 |
Do you need an oil cooler??
|
Hi Boxhead .
Because you have a gen 3 im pretty sure if you look at the side of the sump where your filter is (mine is front left ) at the back of that side i have 2 grub screws in the sump that i have been told that they are presurized with oil by the pump and i could run a cooler from there i dont know how to put a pic in this message so i have put one in gallery Regards Paul |
Paul , David,
Yes the grub screws at the back are connected to the oil gallery. The back one goes to the bearings and the front one is from the pump.I plan to install an accusump in the rear plug and also put oil pressure sensor / switch here also. I have removed front oil filter and added an adaptor then put in a remote filter and cooler. You need to run min -12 for coolers etc. The accusump is purely a preoiler as I figure the extra routing of oil and original design could cause oil starvation on start up. David, I'll measure my cooler and let you know. Phil :D |
I am sure that my car wont need an oil cooler, but they look good :D
I know about the bungs in the sump, and I was going to use them, I havent looked at all into the cost of a cooler setup and just thought these may be a cheap way to get one. |
Hi Boxhead
This is a link to a place here in Adelaide that sell a cooler kit for ls1's http://users.senet.com.au/~dtech/ls1_engine.htm They are 695 |
| All times are GMT -7. The time now is 11:24 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: