06-12-2006, 03:36 PM
|
 |
CC Member
|
|
|
Join Date: Aug 2003
Location: Melbourne. Australia,
VIC
Cobra Make, Engine: Classic Revival kit. LS1 motor. T56 Tremec 6 speed. 17" replica Halibrand wheels.
Posts: 559
|
|
Not Ranked
I too went with Ians setup. Not sure what the cost is but I would think it would quite a job to come up with your own. I still had to heat & bend the brake/clutch pedals over towards the tunnel about 25mm to be more comfy. I used a Ford EA accel. pedal which mounted quite easily but also had to bend the arm to suit a good position. I used the EA cable also, had to reduce its length and fitted new s/steel wire inside and made up the lug at the T/body end. My complaint would be that the pedal travel is a bit too long.
Leeroy
|
Threaded Mode
