Club Cobra

Club Cobra (http://www.clubcobra.com/forums/)
-   B & B Cobra's --- Speak with Bryan Anderson (http://www.clubcobra.com/forums/b-b-cobras-speak-bryan-anderson/)
-   -   Holes for door panels (http://www.clubcobra.com/forums/b-b-cobras-speak-bryan-anderson/37698-holes-door-panels.html)

OhBuoy 01-10-2003 07:25 PM
Holes for door panels
 
What size holes do I drill for those clippy thingys that hold the door interior panels in? Any tricks to lining the holes up?

Tom

Jim Werth 01-11-2003 05:41 AM
I just set the door panel against the door and moved it back and forth just enough to scratch the paint. Marked the spots and drilled the holes. Checked and rechecked alignment after each hole. I dont remember what size I used but it was pretty big. Somewhere around a 1/2 inch bit. If you make them too small good luck getting the panel off if you ever want to again. The clip will tear out of the panel befor it comes out of the door. Jim

cslithergo 01-13-2003 03:29 PM
My instructions say 3/8 inch but I agree that 1/2 inch would be better. I think the clip will probally pull out with the smaller hole. IF you have problems call BJ's Upholstery, 20235 Follage Road, Granby, MO at 417-325-6297. That is who made my interior for B&B amd the number they put in my package. Hope this helps.
Chris

Jim Werth 01-13-2003 10:34 PM
I found my instructions after I had about 90% done. I dont remember a size for the holes written in the instructions. Drill a hole in some scrap plywood and see how the clips fit. Jim


All times are GMT -7. The time now is 08:01 PM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: