|
Radiator panel
Hey,
did anyone built or modified a radiator panel like this for the Backdraft?: http://www.replicaparts.com/nose%20aluminum3.JPG |
Cowling
Check out the Winter 2020 issue of RECARNATION magazine, on page 34 is the article Cobra Cowling. This should answer a lot of your questions.
If you are not getting a hard copy of the magazine (it's free) then check it out at rcnmag.com BillK |
Not sure what year yours is but my 2013 is fine in the front. It is the back flat pan with round hole in rear. The pan should taper and be a little deeper in my opinion . The taper would help the air to move and create less turbulence. The very least ,it should have some pressure relief vents installed, in the rear.
|
| All times are GMT -7. The time now is 10:11 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: