Club Cobra

Club Cobra (http://www.clubcobra.com/forums/)
-   Bay Area Cobra Club (http://www.clubcobra.com/forums/bay-area-cobra-club/)
-   -   Machining 6 pins (http://www.clubcobra.com/forums/bay-area-cobra-club/113028-machining-6-pins.html)

redmt 10-23-2011 04:29 PM
Machining 6 pins
 
Any body have a recommendation for a machine shop to machine the back spacing on my 6 pin Trigo's? Rough measurement has it at 5/8 inch. Prefer Livermore/Modesto + or - 50 miles.

I should have been a little clearer in that I need material removed.

Thanks,
John

289fia_cobra 10-28-2011 06:48 AM
Drop by Rock House in Livermore on Saturday and see who shows up; then start asking. I strongly suspect Tony Repei would have a good idea (or Larry). Livermore guys are slightly knowledge but they're better after their stomachs are full. :D

redmt 10-28-2011 07:14 AM
Quote:
Originally Posted by 289fia_cobra (Post 1158813)
Drop by Rock House in Livermore on Saturday and see who shows up; then start asking. I strongly suspect Tony Repei would have a good idea (or Larry). Livermore guys are slightly knowledge but they're better after their stomachs are full. :D
Thanks but I hooked up With Stockton Wheel. I should b e able to pick them up either today or Monday. $35.00 bucks a wheel including redrilling the depth on the pin holes.:)

Jon Miller 11-06-2011 09:51 AM
Hi John,
A little late on seeing this post........BUT a few years ago I called Lynn Parks (Trigo) about machining 3/8" off the back side of my 5 pin fronts to get the proper track. Lynn told me that there was NO extra material that could safely be removed from the wheels. Your six pins don't use an adaptor, so they may have enough extra material to allow for what you did-I hope!

Good Luck,
Jon


All times are GMT -7. The time now is 08:00 PM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: