- -
Once again!
(
http://www.clubcobra.com/forums/bowtie-snakes/82531-once-again.html)
| Lightingrod |
09-29-2007 06:31 PM |
Once again!
I have a Classic Cobra with a SBC. The Gaskets where the headers meet the side pipes are a joke! Classic says just use Copper Permetex, NOT! I got a piece of .030" copper sheet from a friend in the Sheet Metal business. I made a pattern and cut two gaskets out of the copper. I was thinking one for each side but I wound up putting both on the right side that was leaking at the time. I did use their copper Permetex on all surfaces, it's been great all summer! Of course now the left side is leaking, I still have some sheet and the pattern, so I guess it's time to get out the hole saw again!:3DSMILE:
|
| All times are GMT -7. The time now is 10:06 PM. |
|
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link:
