Club Cobra

Club Cobra (http://www.clubcobra.com/forums/)
-   Classic Roadsters II (http://www.clubcobra.com/forums/classic-roadsters-ii/)
-   -   WTB Carpet set CR 94" wheel base (http://www.clubcobra.com/forums/classic-roadsters-ii/101018-wtb-carpet-set-cr-94-wheel-base.html)

HPCOBRA 11-22-2009 06:51 PM

WTB Carpet set CR 94" wheel base
 
Looking for a carpet set for a 94" Wheel base Classic/Roadster Cobra
Thanks

Hray 11-22-2009 09:05 PM

where are you located, I have two brandnew sets, but I have two cars for them, however if you are close enough you could drop by and make patterns of them.

Ray

HPCOBRA 11-22-2009 09:09 PM

Thanks for the reply.. I am in upstate NY. Where did you get them ?

Hray 11-22-2009 09:38 PM

They came with the two cars I purchased a couple of years back.

You are most likely going to have to make something from scratch. I doubt anyone will have a set for these cars.

My best guess would be to check with Bill emerson in redding Ca. He is still building cars that are nearly exactly the same. if any one knows of a kit he most likely will.

Ray

HPCOBRA 11-23-2009 05:29 AM

I could not find a number for him. If you have one could you send it to me via personal message..
Thanks for your help

tcrist 11-23-2009 05:38 AM

HPCOBRA,
You can find them at www.beyondcobra.com

Terry

Double Venom 11-23-2009 09:52 AM

Ah-Hemm,

Shame on you guys :rolleyes: :MECOOL: !

I DO have a complete, factory sewn set for CR's (94" WB-Is there any other size? - Nope!)

Black in color, With the OEM padding!

All you had to do was ask :)

SURprise-SURprise, SURprise Sgt. ............... (????)

:cool:

DV

Hray 11-23-2009 10:27 AM

Hey DV; we stand corrected and enlightened, so what else you got tucked away in those cubbies that we might be able to use.

Now I know you have roll bars, and carpet. What about a new modern uptodate assembly manual...... (sorry could not resist.).


byeeeeeeeeeeeeeeeee

HPCOBRA 11-23-2009 04:40 PM

I am new to this car and did not know that CR only offered a 94" WB chassis. Someone told me that there were two models!!! My mistake. I just sent a PM to Double Venom. Please get back to me.
Thanks

Double Venom 11-23-2009 05:24 PM

The ONLY KIT COBRA in the World that came with a Certified FORD warranty on the drive trains, Viper V-10 488 C.U. engines with T-6 tranny's, Hydraulic /electrical tilt front ends, four to six inch longer passenger compartments, fitting 17" low profile tires, electric doors, ignitions systems, GPS, every anti theft device known to Cobras, total upgraded racing suspension to the ultimate braking systems, solid axles to full independents, custom dashes up to 18 individual gauges, remote radios, remote controlled doors, nose, trunk lids, patented AND C.A.R.B certified EPA Certified sidepipes, winner of "THE" "Dupont Paint Top Gun Award!, etc., etc. etc .............

AND YOU WANT A MANUAL!!!!!!!!!!!!!!!!!!!! What's one guy supposed to do?! :eek:

Where "We've -gone- "Who Needs A MANUAL? (SO SAYETH THE BOSS, AKA THE WIFE!)

DV

Curt C. 11-25-2009 01:54 PM

I have a brand new red carpet set if anyone is interested.

tcrist 11-25-2009 03:58 PM

Hay Curt,
I never did ask you, is your carpet set trimmed to fit or is it oversized directly from CR?

Curt C. 11-25-2009 07:20 PM

Terry,

Came directly from CR. I assume it is the oversized version but cannot be 100%.

Double Venom 11-26-2009 02:41 AM

Interesting comment!

I never knew CR's had more than one style/set of carpeting for the Cobras? The Tunnel carpeting certainly could have fit a little better!

Oversized??? Something Don slipped by me?

DV

tcrist 11-26-2009 08:38 AM

DV.
The carpet is oversized so you can install it in different configurations as far as I can tell anyway. The edges that require it already has the bindings on them.
Is your carpet precut to fit?

Double Venom 11-28-2009 03:00 AM

The Mud is starting to settle!

There is NO 'cut to fit' carpeting, oversized or not!
I think what you guys are seeing / talking about are the "Floor" pieces that go down first!

These are considered the "Bottom" pieces and go on / in first. What I am assuming, you guys are cutting these to fit? Well they are long-wide made enough to start up the sides of the floor pans/frame rails. Then the top pieces go in with the binding showing, lapping over the floor pieces.

This way their is no possible gap now or when/if the carpet shrinks later on!
Make sense or have I got this all wrong!?
DV

tcrist 11-28-2009 09:37 AM

Good morning DV,
What we are talking about is the actuall carpet. The one that Wetdog has (2007 ? version) is oversized. I borrowed his to have my carpet made. I had went to Hrays and traced out his set (actually my girlfriend did most of the tracing). But I got frustrated with that and borrowed Wetdogs. I am not sure of Curts as I have not actually seen his. My guess is that it is oversized also.

Double Venom 11-28-2009 01:58 PM

OK,
Don had to do something when he finally made the new floor pans! At first he tried or at least just assumed or hoped the original carpeting would fit...It didn't! He then had to have the carpet re-made with the newer designs.

Now we've got guys with the old floor pans (which is the original cut carpeting)and the newer carpeting pieces getting all mixed up, There-for we now have cut/not to cut syndrome!

Ray's should be the original pattern(s) from the late 70's
.
DV

Krewton 11-29-2009 03:21 PM

I'm interested in a brand new set of Black Carpet if anyone still has one. Please email me at levingsk@aol.com

Thanks
Kenton

Hray 11-29-2009 07:43 PM

Kenton: I am going to assume that whey you remade all your foot boxes, floor pans, dropped the seats, remade the tunnel etc... that the likely hood of an original set fitting your car is not too likely. Just my guess, you may have to bite the bullet and take it to a good trim shop.

Ray


All times are GMT -7. The time now is 07:12 AM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: