|
DV: Gasket Material for Side Pipes ?
DV: Your suggestion on the material for the gasket in-between the side pipes and headers ? With the gasket, use a sealant ? If so, which one ?
Any other hints....... ..........thanks |
Don,
Not to sound petty, but I haven't used any gasket since the first Cobra I built. I use 3M's gold Hi-heat Silicone, or the same in black. I coat the headers only with a full coat, circling each tube. Instantly attach the sidepipes, let it cure for 24 hours and trim off the excess with a razor blade. You can fire it up 20 minutes after the two parts are attached, I just give it the extra time to cure before trimming. Hope this helps..... |
DV:
" 3M's gold Hi-heat Silicone, or the same in black. " thanks..... |
| All times are GMT -7. The time now is 07:43 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: