Parts for 427 CRII

[tcrist]

Any good tubing bender can make the roll bar. Take yours out and have them bend one up. The only difference is what side/angle you weld the short down tube on and then the bend in the long down tube.

They might even be able to make the two tube plugs and weld it up for you. Again the word MIGHT!!

Don't know what you are going to do for another attachment for the long down tube to the frame. The stock CR one was pretty flimsy.

Remember, these roll bars for the CR (as for most of the kit manufacture roll bars) were made for looks only.

[BA0073]

Thank you for the info. As I looked at my car closer I realized they were not for safety but for appearance. I wanted to put it on the track (in time)but It was mostly for a second roll hoop for my wife or kids who ride with me. I will look into someone with a tube bender that would bend this. Love my car just wish there were parts out there to buy for it.
Thank you again,
Bryan