- -
Head lights
(
http://www.clubcobra.com/forums/classic-roadsters-ii/141270-head-lights.html)
| Bulldog |
08-01-2018 08:49 AM |
Head lights
Bulldog here again with another question my head lights seem to be dim while driving at nigh they are sylvania halogen but just don't seem to be as bright as they should be have no electrical problems with car runs fine starts grgreat.shas anyone had similar problem?
|
| Alfa02 |
08-01-2018 09:20 AM |
@Bulldog, check your headlight ground connection, I know mine still had paint between it and the frame. Ground the paint off, lights are now bright. I know of a few other CR owner that have had the same problem. Good place to start. Cheers Tom.
|
| Ron61 |
08-01-2018 10:34 AM |
I had that problem with mine and the voltage at the lights was not what it should have been. Everything checked out good including grounds and relays so I ran a new power lead to them and it worked OK. I never could find why the original lead had low voltage so I finally just cut it out. My first thought was a bad ground or connection at the relay but that didn't prove out.
Ron
|
| Bulldog |
08-01-2018 12:23 PM |
Head.ights
Thanks guys for the quick reply that what I like about our forum great info. I will check all grounds thanks again .Later Bulldog.
|
| studebaker53 |
08-02-2018 08:30 PM |
Also make sure the 3 plug connector that plugs into the headlight is right. Sometimes the wires get mixed up.
|
| MOTORHEAD |
08-03-2018 06:35 AM |
What size are the wires feeding the headlights? Typically older cars (and Cobra replicas) were wired with 18-16 ga wire. They aren't large enough for Halogen bulbs, which draw more current . My kirkham ,with it's old time wiring has the same problem with it's sealed beams, as did my '68 and '86 Porsche's when I switched them to H-4's. You need to run bigger wires from relays, and feed the relay's direct to battery through fuse or ckt breaker to maintain 14vdc at the bulb.
Ted
|
| Bulldog |
08-03-2018 06:01 PM |
Thanks motorhead another good reply about head lights willcheck wires
|
| joyridin' |
08-03-2018 08:25 PM |
Are the headlights set-up on relays? Most Cobras that I have seen run all the power through the switch.
I ran relays to the high and low beams and ran a 10 nice hefty input wire into the relay. They are definitely not dim anymore.
|
| All times are GMT -7. The time now is 04:26 PM. |
|
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: