|
Door opening cutouts
Hey Don!
Getting ready to cut out my door openings. The factory guide markings are different on each side. %/ After cutting the openings, do I end up with a vertical surface or a horizontal one (at the sill)? Thanks! Dwain |
Horizontal,cut inside of line and grind to final surface. Trial fit the piece of carpet that is intended for this area and that will show you how much to take off.
|
Thanks, Art!
Don't have the carpet yet but this'll get me going in the right direction. Dwain |
Dwain, what Art said!
Don |
| All times are GMT -7. The time now is 10:06 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: