|
Rolled body edge question
How have most of your cars had the inside hood opening edge finished. Just rounded off a little to a 1/8 inch radius or so to knock the sharp edge off - or rolled like the cockpit edges.
What are most cockpit edges rolled to - seems I remember they used 3/4 inch tube there on original cars but I may be wrong with that - 1/2 inch finished radius? Thanks Dan |
We have never done the full-radius thing on the hood or trunk opening. Just smooth off the corner so that you don't cut yourself. I don't remember exactly, but I don't think that the backup tube bonded into the sides goes the entire length anyway.
|
That's what I hoped you would say.
On the cockpit edges - is about 1/2 inch radius what they are doing? Thanks Dan |
| All times are GMT -7. The time now is 05:56 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: